ملخص المحتوى في الصفحة رقم 1
INSTALLATION INSTRUCTIONS
LAT-NR100
LED Tail Lights for 1967-68 SS and 1970-73 Camaro.
MAN# 650153
Kit Includes:
Installation: 67-68 SS Camaro 70-73 Camaro
1. Remove the tail light assembly from the vehicle by removing the original bulb sockets from the
housing. Then remove the housing hardware so it can be removed from the car. Remove the
housings from the vehicle carefully so the housing to body gaskets are not damaged.
2. Next remove the lens.
The
ملخص المحتوى في الصفحة رقم 2
3. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended. If you are installing this kit into a 67-68 Camaro skip ahead to step 5. For the 70-73 Camaro, some of the hardware will need to be changed out for proper mounting bracket 4. Changing the installed 67-68 mount bracket to the 70-73 mounting bracket. a. Note how the current assembly is attached and notice how the wires are routed for re- assembly. ENSURE THE WIRES ARE NOT PINCHED IN TH
ملخص المحتوى في الصفحة رقم 3
7. Feed the wires through the larger hole in the mounting plate. Guide the mounting plate to the bottom of the housing. The flat side of the mounting plate should be down and the side with the slight raised center should go up into the housing. This will align the mount in the original housing. 8. Now hold the LED assembly so that it is centered over the hole where the original bulb was located and align the mounting plate from the bottom with the slot in the housing. The screw h
ملخص المحتوى في الصفحة رقم 4
11. Start by cutting off the existing light socket as it will not be used. Do not strip wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 12. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *Fo
