ملخص المحتوى في الصفحة رقم 1
PLUS4600UM 1/30/02 10:28 AM Page 1
R
Vehicle Security
OWNER’S
MANUAL
Models: PLUS-4600
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Suc
ملخص المحتوى في الصفحة رقم 2
PLUS4600UM 1/30/02 10:28 AM Page 2 Congratulations on your purchase of a quality Carbine Automotive security system. Carbine automotive security products have been designed to provide the consumer with a product that is technologically superior and will provide years of trouble free operation. The information enclosed will provide a ready reference of the operation and maintenance of your new Carbine security system. Remote Control Transmitters Your Carbine security system operates from this
ملخص المحتوى في الصفحة رقم 3
PLUS4600UM 1/30/02 10:28 AM Page 3 Automatic Arming: (Without using the transmitter) Note: The following information is valid only if your security system has been programmed to automatically arm. 1. Turn off the ignition key and exit the vehicle. 2. Close all protected entrances. After the last protected entrance is closed the horn/siren will chirp one time and the LED indicator will begin to flash fast. The fast flashing LED indicates that the automatic arming timer is counting down and th
ملخص المحتوى في الصفحة رقم 4
PLUS4600UM 1/30/02 10:28 AM Page 4 Valet/Override Switch Operation: ON ON ON ON ON ON OFF OFF OFF OFF OFF OFF Valet Switch in the ON Position Valet Switch in the OFF Position Override Operation: (Security System is Armed) 1. Enter the vehicle (The security system will begin sounding at this point) 2. Place the ignition key into the ignition switch and turn the ignition switch to the “on” position. 3. Within 5 seconds of turning the ignition key “on”, flip the valet switch to the “on” positio
ملخص المحتوى في الصفحة رقم 5
PLUS4600UM 1/30/02 10:28 AM Page 5 Remote Panic Press and hold the PANIC or LOCK button for more than 3 seconds and the security system will respond in the following manner: A. The horn/siren will begin sounding. B. The parking lights will begin flashing. To turn off the panic alarm, press and release the UNLOCK or PANIC button on the transmitter. The horn/siren will stop sounding and the parking lights will stop flashing. Note 1: If you do not turn off the panic feature with the transmitter
ملخص المحتوى في الصفحة رقم 6
PLUS4600UM 1/30/02 10:28 AM Page 6 Alarm Mode Indicators 1. The LED indicator will provide information on 7 modes of security system operation: LED is off = Security system is disarmed. LED is flashing = Security system is armed. LED is flashing fast = Automatic arming timer or RF protection mode timer is counting down. LED is on solid = Security system is in valet mode. (Only when the ignition key is on) LED is flashing once every 5 seconds = Security system is in valet mode (Only when ig
ملخص المحتوى في الصفحة رقم 7
PLUS4600UM 1/30/02 10:28 AM Page 7 Upgrade Options Option #5: Starter Disable Relay Adding option #5 will increase the level of protection that your Carbine security system can offer. When the starter disable relay is installed, the vehicles engine will not crank when the alarm system is in the armed mode. Option #6: Dual Zone Shock Sensor Installing option #6 will increase the level of security provided by your Carbine security system. Zone #1 of the dual zone shock sensor will detect lig
ملخص المحتوى في الصفحة رقم 8
PLUS4600UM 1/30/02 10:28 AM Page 8 System Maintenance: The only maintenance that your Carbine security system requires is a periodic check of it’s operation to be sure that all functions are operating properly. The batteries supplied with your transmitter will usually last about 1 year. Heavier usage will shorten battery life. Reduced transmitter range is usually a sign that the battery in the transmitter is becoming weak and should be replaced. Note: The battery supplied with transmitter (A
