ملخص المحتوى في الصفحة رقم 1
Owner's Guide
ملخص المحتوى في الصفحة رقم 2
Limited Lifetime Consumer Warranty For a period of one calendar year from the date of purchase of this auto-security device, Directed Electronics, Inc. promises to the ORIGINAL PURCHASER to repair or replace (with a comparable reconditioned model), free of cost, any electronic control module which proves to be defective in workmanship or material under normal use, SO LONG AS THE SYSTEM WAS SOLD, INSTALLED, AND SERVICED BY A PROFESSIONAL AUTO INSTALLER, AND REMAINS IN THE CAR IN WHICH THE SYST
ملخص المحتوى في الصفحة رقم 3
These systems are a deterrent against possible theft. Directed Electronics, Inc. is not offering a guarantee or insuring against the theft of the automobile or its contents and disclaims any liability for the theft of the vehicle and/or its contents. Directed Electronics does not authorize any person to create for it any other obligation or lia- bility in connection with this security system. TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUD- ED BY THE MANUFACTURER AND EACH
ملخص المحتوى في الصفحة رقم 4
Table of Contents Limited Lifetime Consumer Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . i What Is Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 System Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 FCC/ID Notice. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ملخص المحتوى في الصفحة رقم 5
Standard Configuration controls the Arm function. controls the Disarm function. controls Silent Mode™and an Auxiliary Output. controls the Panic function. and pressed simultaneously control Remote Start. and pressed simultaneously control an Auxiliary Output. 2 2000 Directed Electronics, Inc. ©
ملخص المحتوى في الصفحة رقم 6
What is Included A control module Two four-button remote transmitters A dual-stage shock sensor (on-board the control module) A soft chirp, six-tone siren A red status LED indicator light A push-button Valet switch A starter interrupt relay Important Information Congratulations on the purchase of your state-of-the-art vehicle security system. This system has been designed to provide years of trouble-free operation. By carefully reading this owner's guide, you will maximize the us
ملخص المحتوى في الصفحة رقم 7
FCC/ID Notice This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interfer- ence received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. Transmitter Functions Your vehicle security system is progr
ملخص المحتوى في الصفحة رقم 8
LOCK/ARM Button Pressing arms the security system and locks the vehicle doors. UNLOCK/DISARM Button Pressing disarms the security system and unlocks the vehicle doors. AUX Button Silent Mode and trunk release are controlled by pressing . (Pressing for less than one second before arming or disarm- ing activates Silent Mode. Pressing and holding for 1.5 seconds engages the trunk release.) PANIC Button Pressing and holding for 1.5 seconds activates the Panic Mode. LOCK/ARM and UNLOCK/DISARM Button
ملخص المحتوى في الصفحة رقم 9
Using Your System Remember, use of the buttons described in all instructions in this manual corresponds to the Standard Configuration, unless other- wise specified. Arming You can arm the security system and lock your vehicle's doors by pressing for one second. When the system arms, you will hear a short siren sound (chirp) and the parking lights will flash once. Once armed, the status LED will flash once per second to indicate that the system is actively protecting your vehicle. If you hear a s
ملخص المحتوى في الصفحة رقم 10
Passive Locking) and the status LED will begin flashing once per second to indicate armed status. If the system is programmed for Passive Locking, care must be taken to prevent the keys from being locked in the vehicle. NOTE: If any protected entry point (such as a door or switch-protected trunk or hood) is open, Passive Arming will not engage. Additionally, each time a sensor is triggered during the 30-second arming countdown, the countdown starts over. Arming your security system protects your
ملخص المحتوى في الصفحة رقم 11
Arming While Driving This feature provides added security while travelling in an unfa- miliar or potentially dangerous area. To arm your security system while driving, press on the transmitter for 1.5 seconds while the vehicle is running or the ignition is on. You will hear one chirp that confirms the system has been armed, followed by another chirp that indicates the ignition is on. While the vehicle is running, the security system will not respond to any input except the door triggers; the sta
ملخص المحتوى في الصفحة رقم 12
longer than six seconds, press to stop the trigger and reset the system to its armed state. Pressing an additional time will disarm the system. To disarm the system immediately, press during the first six seconds of the Triggered Sequence. Disarming Without a Transmitter If your remote transmitter is lost or damaged, you can manually disarm your vehicle security system. To disarm the system without a transmitter, you must have the vehicle's ignition key and know where the Valet switch is locate
ملخص المحتوى في الصفحة رقم 13
Silent Mode Use the Silent Mode to temporarily turn off the arm or disarm confirmation chirps by briefly pressing before either arming or disarming. The confirmation chirp(s) will then be eliminated for that one operation only. To permanently turn off the arm and disarm confirmation chirps, contact your installation dealer. NOTE: The Warn Away Response to lighter impacts is bypassed if the security system is armed using the Silent Mode. This ensures that the siren does not chirp in an enviro
ملخص المحتوى في الصفحة رقم 14
To enter or exit Valet Mode: 1. Turn the ignition on. 2. Turn the ignition off. 3. Press and release the Valet DRW-35 switch within 10 seconds. The status LED will light steadily if you are entering Valet Mode and will turn off if you are exiting Valet Mode. Remote Valet You can also activate Valet Mode with the remote transmitter: 1. Open any vehicle door. 2. Press . 3. Press . 4. Press again. The status LED will light solid if you are entering Valet Mode and will turn off if you are ex
ملخص المحتوى في الصفحة رقم 15
your system ignores, or bypasses, that sensor or switch (along with any other sensors or switches sharing the same zone) for 60 minutes. If the bypassed sensor is triggered again while it is already being bypassed, the 60-minute bypass period will start over. This ensures that a sensor that is continually being triggered will remain bypassed. The vehicle doors are protected differently. If your security system is triggered by an open door for three, full 30-second cycles (one and one half minut
ملخص المحتوى في الصفحة رقم 16
Arming Diagnostics If the system is armed at the same time that an input is active (door opening, sensor triggering, etc.), you will hear one chirp to indicate arming and a second chirp to indicate Bypass Notification. A Bypass Notification chirp means that the system ignores the input that was active when the system was armed, until that input ceases. Three seconds after that input ceases, the system will resume normal monitoring. For example, if your vehicle has an interior light exit delay an
ملخص المحتوى في الصفحة رقم 17
Table of Zones A zone is represented by the number of LED flashes used by the system to identify a particular type of input. Standard input assignments are listed below, along with spaces to write in any optional sensors or switches that have been installed. ZONE (Number of DEALER-INSTALLED LED Flashes) DESCRIPTION OPTIONS 1 Instant trigger - often used for hood/trunk pinswitches 2 Instant trigger - a heavier impact detected by the Shock Sensor 3 Door switch trigger 4 Instant trigger - for optio
ملخص المحتوى في الصفحة رقم 18
Code Hopping The receiver and transmitter use mathematical formulas called algorithms to change their codes each time the transmitter is used. This Code Hopping technology has been developed to increase the security of the unit. By following this set code sequence, the receiver and transmitter stay synchronized, even if the remote transmitter is used out of range of the vehicle. If, however, the transmitter is pressed many times out of range of the vehicle, or the battery is removed, the tran
ملخص المحتوى في الصفحة رقم 19
Multi-Vehicle Operation Your vehicle security system has the ability to interface with other vehicle security systems to control multiple vehicles using the same transmitter. Contact your local dealer for more details. Programming Options Programming options control your system's normal, operational set-up. Most options do not require additional parts, but some may require installation labor. The system's programming options are listed below, with the factory default settings in bold: Active A
ملخص المحتوى في الصفحة رقم 20
Valet Switch Pulse Count: The number of times you must press the Valet switch in order to disarm the security system. One to five pulses can be programmed by the installer. Siren Tones and Chirp Volume: The output of the siren con- sists of six different tones in sequence. Installation Options Your security system has some options that may require extra parts and labor. One of these options, Progressive Unlocking, configures the system so that when you press to disarm, only the driver's doo
