ملخص المحتوى في الصفحة رقم 1
INSTALLATION GUIDE FOR
WHIRLPOOLS AND BATHTUBS
CORNER DUET W/SEAT 60" x 60" MODEL 2351
CENTURION 6' x 36" MODEL 2371
CONTEMPO OVAL MODEL 2383
FREE SPIRIT 6' x 54" MODEL 2466
THANK YOU...
for selecting an American Standard bath. Your new bath is shipped to you after careful inspection. The
whirlpool version is completely assembled with pump, motor, and system piping. All you need to finish the
whirlpool installation are your selected fittings and electrical connections.
To insure maxi
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS: Safety Instructions............................................................................Page General Information..........................................................................Page 4 Optional Components.......................................................................Page 4 Specifications....................................................................................Page 4 Roughing-in Reference........................................................
ملخص المحتوى في الصفحة رقم 3
IMPORTANT SAFETY INSTRUCTIONS INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS READ AND FOLLOW ALL INSTRUCTIONS! ! WARNING: Risk of personal injury. Do not permit children to use this unit without adult supervision. ! WARNING: Risk of personal injury. Do not operate this unit without the guard over the suction fitting. ! WARNING: Risk of electric shock. Do not permit electrical appliances (hair dryer, telephone, radio, etc.) within 0 inches (154mm) of this unit
ملخص المحتوى في الصفحة رقم 4
General Installation Information Carefully uncrate and inspect your new bath for any shipping damage. If such damage is found, report it to your vendor immediately. After inspection and during installation, protect the bath from construction damage. Before installation, and before enclosing with wallboard, tile, etc., the bath must be filled with water and operated to check for leaks that may have resulted from shipping damage or mishandling! Do not make modifications to the whirlpool system
ملخص المحتوى في الصفحة رقم 5
ROUGHING-IN REFERENCES CORNER DUET WITH SEAT 60" x 60" (MODEL 2351) CENTURION 6' x 36" (MODEL 2371) 72" 34" (1829mm) (864mm) 59-3/4" 59-3/4" (1518mm) (1518mm) 60-1/2" (1537mm) 36" (914mm) PUMP LOCATION 27-1/2" (699mm) 6" PUMP 22-1/4" (152mm) LOCATION 12-5/8 (565mm) 10" 45-1/2" (321mm) (254mm) (1156mm) 84-1/2" (2146mm) GENERAL SPECIFICATIONS FOR 2351 GENERAL SPECIFICATIONS FOR 2371 INSTALLED SIZE 72 x 36 x 21-3/4 In.(1829 x 914 x 552mm) INSTALLED SIZE 84-1/2 x 60-1/2 x 20-1/2 In.(2146 x 1537 x 52
ملخص المحتوى في الصفحة رقم 6
INSTALLATION AND FRAMING INSTRUCTIONS The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs as needed. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for access to the drain components. The apron should not be used as the primary access openin
ملخص المحتوى في الصفحة رقم 7
TYPICAL FLANGE MOUNTING DETAIL TYPICAL INSTALLATION - CORNER SUGGESTED WHIRLPOOL / BATH INSTALLATION METHOD WOOD STUD STUDS WATERPROOF DRYWALL OR CEMENT BOARD 1 TILE (4mm) ROOFING NAIL SEALANT WHIRLPOOL ACCESS PANEL TUB UNLESS AN ACCESS OPENING OF AT LEAST 12" x 24" (305 x 610mm) IS PROVIDED, WARRANTY SERVICE WILL NOT BE PERFORMED. 1 x (5 x 7mm) WOOD STRINGER FULL LENGTH STEEL STEEL PIER CUTOUTS STUD STUDS Installation of a whirlpool in a platform requires a cutout. Many whirlpools
ملخص المحتوى في الصفحة رقم 8
WHIRLPOOL ELECTRICAL INSTALLATION INSTRUCTIONS All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes. WARNING: When using electrical products, basic precautions should always be observed, including the following: ! 1. DANGER: RISK OF ELECTRIC SHOCK! Connect only to a circuit protected by a ground-fault circuit interrupter. . Grounding is required. The unit should be installed by a licensed electrician and ground
ملخص المحتوى في الصفحة رقم 9
DRAIN CONNECTION AND SYSTEM TEST Using recommended drain assembly, connect whirlpool drain to waste line in accordance with the drain assembly instructions. Tighten all drain joints securely. Check the pump couplings and make sure they are hand-tight. Clean the whirlpool and fill with water to a point " above the top of the highest jet. Recheck the pump couplings and make certain that they are not leaking. (Although the pump couplings are factory tightened and inspected, some loosening
ملخص المحتوى في الصفحة رقم 10
AS AMERICA, INC. (AMERICAN STANDARD) LIMITED LIFETIME WARRANTY FOR ACRYLIC WHIRLPOOLS AS America (“American Standard”) warrants to the original consumer purchaser that it will, at its option, repair or replace this whirlpool or any of its parts that are found by American Standard, in its sole judgment, to be defective under normal residential use and maintenance so long as it is owned by the original consumer purchaser. This warranty shall only become effective upon receipt by American Standa
