Whirlpool WGD97HEX دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Gas Dryer
PRODUCT MODEL NUMBERS
WGD94HEX, WGD95HEX, WGD97HEX
Front view: Side view:
27"
(686 mm)
1
38 /8"
(968 mm)
* Approx. measurement
3
/4"*
NOTE: Most installations require a minimum 5" (102 mm)
(18 mm)
clearance behind the dryer for the exhaust vent with elbow.
Back view:
See “Venting Requirements”.
1
6 /4"
Recommended installation clearances (dryer only):
(159 mm)
3"
(76 mm)
18" min.
2
7
48 in. min.
29 /8"*
(457 mm)
2
(310 cm )
(759 mm)
Water
3
5 /4"*
Vent 1
3 /2"*
(146 mm)
(89 mm)
Ga

ملخص المحتوى في الصفحة رقم 2

INSTALLATION REQUIREMENTS GAS SUPPLY REQUIREMENTS Gas supply: This dryer is equipped for use with Natural gas. Dryer can be converted to L.P. gas. When rigid pipe is used it should be 1/2" IPS. When acceptable to the gas supplier and local codes, 3/8" approved tubing may be used for lengths under 20 ft (6.1 m). For lengths over 20 ft (6.1 m), larger tubing should be used. Pipe-joint compounds resistant to the action of L.P. gas must be used. An individual manual shutoff valve must be installed