ملخص المحتوى في الصفحة رقم 1
MODEL HR-180T1
REFRIGERATORS
OPERATING
INSTRUCTIONS
The manufacturer keeps on developing various
*
types of refrigerators, so he has the right to modify
designs, products and technical data without further
notice.
ملخص المحتوى في الصفحة رقم 2
FIGURATION OF THE REFRIGERATOR 7 8 6 0 1 5 2 4 3 5 1 4 2 3 1. Low bottle support 2. High bottle support 3. Vegetable box 4. Shelf 5. Drip tray 6. Evaporator 7. Thermostat 8. Light Switch The manufacturer reserves the right to improve the product from time to time without further notice. 1
ملخص المحتوى في الصفحة رقم 3
NOTICE Never store anything dangerous The power supply HR-180T1 127v,60HZ in the appliance, such as HR-180T2 220V, 50/60Hz combustibles, exposives, Single phase. strong acid and alkali. etc. It is not recomended to use any extention cords. Connect the appliance with a properly earthed three-wire plug and socket with a special use. SETTING UP The appliance can be placed with its rear panel directly against the wall. For a good air circulation, the vent grille at the back of the worktop mu
ملخص المحتوى في الصفحة رقم 4
THERMOSTAT The knob graduation 0, 1, 2, 3, 4, 5, 6, 7, does not stand for concrete temperature.The smaller the numbers,the higher the temperature in the compartment and vice versa.Usually,it’s better to put the thermostat in Pos. “1”,Pos. “4”.Pos. “0” shows the power is cut off. STORING FOOD The temperatures in different positions inside the refrigerator are different due to different 1 5 refrigeration distribution.Thus when store food, select proper position to meet your 2 needs. 4 3 The col
ملخص المحتوى في الصفحة رقم 5
NOTES ON STORAGE Where necessary, food should be packed in bags, avoiding giving off strong odours or getting wet or dry. Do not store food too full in the appliance. Allow space among the packages of food for a perfect refrigerating. Hot food or liquid must be allowed to cool to room temperature before placing in it. CLEANING The appliance can only be cleaned at drawn network plug. Clean it with lukewarm water containing a little detergent. In any case do not use hot water,corrosive scouring
ملخص المحتوى في الصفحة رقم 6
DEFROSTING When defrosting, switch off the appliance. Remove food from the ice chamber,it will be defrosted automatically.When 4~6mm defrosting process has been completed, the drip-tray should be depleted. Replace the food and switch on the appliance. NOTES If the appliance The appliance door remains out of should be opened as use for some time, little and briefly pull out the plug as possible to reduce to disconnect the energy consumption appliance from power supply. Clean the interior as descr
ملخص المحتوى في الصفحة رقم 7
In the event of a fault occurring during operation, check first if the fault is due to an operation error. You can repair the following faults yourself. 1. It is not switched on properly, or mains plug properly inserted The appliance does in the socket. not run. 2. The thermostat knob is turned to position “0”. 3. Supply voltage is too low. 1. The appliance is too full of food. 2. The appliance is located too near The temperature inside a source of heat. the appliance is not
ملخص المحتوى في الصفحة رقم 8
LAMP AND LAMP REPLACEMENT Lamp: HR-180T1 127V,15W. HR-180T2 220V, 15W Lamp holder: E14 (lamps exceeding 15W must not be used) When replacing the lamp: * Unplug to disconnect the power and remove the water tray. * Press the positioning pin of the lamp with left hand, and release the shade from the lamp holder by sliding it to the right side. Turn the lamp anti- clockwise for removing. * Replace the water tray. Light Shade ELECTRICAL DIAGRAM Thermostat Overload C Protector Plug Switch S S
ملخص المحتوى في الصفحة رقم 9
ملخص المحتوى في الصفحة رقم 10
ملخص المحتوى في الصفحة رقم 11
ملخص المحتوى في الصفحة رقم 12
ملخص المحتوى في الصفحة رقم 13
ملخص المحتوى في الصفحة رقم 14
ملخص المحتوى في الصفحة رقم 15
ملخص المحتوى في الصفحة رقم 16
ملخص المحتوى في الصفحة رقم 17
ملخص المحتوى في الصفحة رقم 18
