ملخص المحتوى في الصفحة رقم 1
®
USE AND CARE GUIDE
CLEAR & CLEAR COMBO® MODELS
CLEAR ICE & CLEAR ICE COMBO MODELS
CLR2160OD Outdoor CLR2160 Stainless
CLRCO2175
The Built-In Undercounter Leader Since 1962 U-LINE.COM
ملخص المحتوى في الصفحة رقم 2
Introduction Please Record Your Model Information You will need your product model and serial number when you request additional information or services. You can find this information on the serial plate located on the upper right or back Congratulations on your purchase of a U-Line refrigeration wall in the interior of your product. This information also appears product. on the warranty registration card. Building on 45 years, U-Line has captivated those with an appreciation for the finer
ملخص المحتوى في الصفحة رقم 3
1 Table of Contents U-Line Clear Ice & Clear Combo® Models i - Introduction .................................................................................................................................................................i Read and save this Use and Care Guide. .........................................................................................................i Please Record Your Model Information .............................................................................
ملخص المحتوى في الصفحة رقم 4
2 U-Line Use and Care Guide
ملخص المحتوى في الصفحة رقم 5
2 Safety Precautions General Precautions Use this appliance for its intended purpose only and follow these IMPO IMPOR RT TANT ANT general precautions with those listed throughout this guide: • PLEASE READ all instructions before installing, operating, or servicing the appliance. DANGER RISK OF CHILD ENTRAPMENT. Before you throw away your • Proper installation procedures must be followed when old refrigerator or freezer, take off the doors and leave shelves completing an installation or relo
ملخص المحتوى في الصفحة رقم 6
3 Product Features Model Features: Combo® Model Features: High daily ice production and storage. The CLR2160 Clear ice production capability plus refrigeration all in one produces up to 60 pounds of ice per day and stores up to 30 unit. Both clear ice capability and refrigeration all in on 24” wide pounds. While the CLRCO2175 can produce up to 40 pounds or compact unit. ice per day and store up to 15 pounds. Three glass shelves. Maximizes storage capacity and easy to Electronic control m
ملخص المحتوى في الصفحة رقم 7
4 Product Operation Adjusting Air Temperature CLRCO2175 Air Flow IMPO IMPOR RT TANT ANT IMPO IMPOR RT TANT ANT Adjust the set point temperature in single increments, The unit requires proper air flow to perform at its highest and wait 24 hours for the temperature to stabilize before efficiency. Do not block the front grille or internal fans at rechecking. any time, or the unit will not perform as expected. Do not install the unit behind a door. 12 3 4 5 Note: The CLRCO2175 refrigerator sec
ملخص المحتوى في الصفحة رقم 8
Interior Lighting Checking Product Temperature Normal Operation. Opening the door will cause the interior of the cabinet to illuminate. Use the LIGHT icon (5) on the control panel to change the lighting functions. 12 3 4 5 Blackout (Sabbath) Mode. The interior of the cabinet and control display remains darkened for a 36-hour period (Blackout (Sabbath) Mode is not Star K certified). To turn the lights and display OFF for a preset 36-hour interval. To check the actual product temperature in th
ملخص المحتوى في الصفحة رقم 9
Electronic Control Quick Guide Task Touch Touch Display Comment Turn ON/OFF Hold 5 seconds Release when °F flashes. or °F flashes after first touch, or or Adjust set-point saved after 5 Temperature seconds of inactivity and °F Touch and release Touch to change temperature stops flashing. CLRCO2175 View Actual WC models will scroll top/ Hold 5 seconds Release when °F flashes. Temp mid/bottom temps. CLRCO2175 Change F/C Hold or CLRCO2175 Blackout will end in 36 Display (and cabinet l
ملخص المحتوى في الصفحة رقم 10
Cle 4. Remove the standpipe by lifting it up while using a slight back and 5 Clear Ice Maker forth motion to loosen it from the drain hole. The water in the reservoir will flow down the drain. Clear Ice Maker Cleaning Cycle Interval - Every 3 Months To maintain operational efficiency, clean the unit every three months (depending on water conditions, more or less frequent cleaning may be necessary). If the ice maker requires more frequent cleaning, consult a qualified plumber to test the w
ملخص المحتوى في الصفحة رقم 11
The unit will resume operation approximately 15 minutes after the Ice cubes in any given batch will vary, so it is necessary to choose automated cleaning process is completed. The water fill valve will cubes from the sample area for comparison when making energize, fill the water reservoir, and shut-off after three minutes. adjustments. If further adjustments are desired, repeat Steps 1 The compressor begins to operate and water flows over the through 4. evaporator assembly (ice cube tray). I
ملخص المحتوى في الصفحة رقم 12
6 Maintenance Removing and Installing Interior Shelves Leveling 1. Pull shelf out about 6" (Figure 40) until back of shelf clears the "hump" on the right-hand IMPO IMPOR RT TANT ANT side. Unit must be level, for proper door and ice maker (if equipped) operation. 2. Tilt right-hand edge of shelf 2 up. Remove shelf from unit by 1 pulling out. Insert the shelves as follows: 1. To move to a different position in the unit, insert shelf at an angle, approximately 15°-20°, over the rib in the
ملخص المحتوى في الصفحة رقم 13
Removing and Installing Grille Removing and Installing Door Shelves WARNING Disconnect electric power to the unit before removing 1 the grille. WARNING DO NOT touch the condenser fins(4). The condenser fins are SHARP and can be easily damaged. Removing the grille. 1. Disconnect power to the unit. 2. Remove control knob (6) if equipped. 2 3. Loosen the two screws (1). Some models may have only one screw in the center. 4. Remove grille (2) and grille cap (if equipped)(3) from unit. Installing t
ملخص المحتوى في الصفحة رقم 14
9 Self-Closing Doors Door Alignment and Adjustment Align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior. IMPO IMPOR RT TANT ANT • Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door 4 (no gaps). Carefully examine the door’s gasket to ensure that it is firmly in contact with the cabinet. Also 5. After adjustment i
ملخص المحتوى في الصفحة رقم 15
To reverse the door: Remove existing bottom hinge. Remove the existing bottom hinge (three screws) (2). Reinstall hinge to top opposite. 3 1 Install the hinge just removed from the bottom to the TOP opposite side of the cabinet (three screws) (2). Reinstall Hole Plugs. Install plastic screw plugs (three each, top and bottom) (3) into holes where hinge hardware was removed. 2 Remove door: 1 1. Hold door to keep it from falling. 2. Remove hinge screw pin (1) from top hinge using a Phillips scre
ملخص المحتوى في الصفحة رقم 16
. 8 Cleaning Defrosting Automatic Defrost Models Exterior Cleaning Frost on the rear wall is normal and will melt during each off cycle. If there is excessive build-up of 1/4” or more, manually defrost the Vinyl Clad (Black or White) Models: unit. • Clean surfaces with a mild detergent and warm water solution. • Ensure the door is closing and sealing properly. Do not use solvent-based or abrasive cleaners. Use a soft • High ambient temperature and excessive humidity can also sponge and ri
ملخص المحتوى في الصفحة رقم 17
Condensor Cleaning Storage, Vacation and Moving Interval - Every Six Months If not using the unit for an extended period, or otherwise stored, follow these steps completely: To maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending WARNING on environmental conditions, more or less frequent cleaning may be necessary. Electrical Shock Hazard. Disconnect power before servicing. Before operating, replace all panels. Fa
ملخص المحتوى في الصفحة رقم 18
9Service Troubleshooting Guide Before Calling for Service DANGER If you think your U-Line product is malfunctioning, read the ELECTROCUTION HAZARD. Never attempt to repair or OPERATION section of this guide to understand clearly the perform maintenance on the unit until disconnecting the function of the control. main electrical power. If the problem persists, read the NORMAL OPERATING Troubleshooting - What to check when problems occur: SOUNDS and TROUBLESHOOTING GUIDE section of this guid
ملخص المحتوى في الصفحة رقم 19
U-Line Corporation Limited Warranty 1. U-Line Corporation ("U-Line") warrants each U-Line continue to be covered by the warranty terms set forth in product to be free from defects in materials and Paragraphs 1 and 2 above, to the extent such models: workmanship for a period of one year from the date of purchase. U-Line further warrants the sealed system A. Are subjected to temperatures between 50 and 100 (consisting of the compressor, the condenser, the degrees Fahrenheit. Although thes
ملخص المحتوى في الصفحة رقم 20
® USE AND CARE GUIDE PRODUCT INFORMATION Installation Guides with complete installation information, Custom Wood Panel Size Specifications & Installation Instructions, CAD Drawings, Use and Care Guides, Specifications & Feature Benefits are available for viewing and download on-line at www.u-line.com/specs/. SERVICE INFORMATION If you have a problem with this appliance, your use and care guide has troubleshooting information to help you quickly identify common problems and provide informatio
