Amana IC4 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

®
IC4
Side-by-Side
Refrigerator
Ice Maker Kit
Installation and
Operating
Instructions
Keep these instructions for future reference. Be sure this
manual stays with the ice maker.

ملخص المحتوى في الصفحة رقم 2

Introduction Parts Use listed part numbers only when ordering replacement parts. Part numbers are not used in installation ! CAUTION instructions. To avoid personal injury or property damage, observe all safety instructions. Verify proper ice maker kit model, listed on wiring diagram 3 on back of refrigerator. Read entire manual before 7 installing kit. All necessary tools and materials must be 5 available prior to installation. Verify all listed parts are 2 included in kit. If parts are missing

ملخص المحتوى في الصفحة رقم 3

Materials Required Important • Before connecting ice maker, contact a plumber to connect copper tubing to household plumbing in compliance with local codes and ordinances. • Amana Appliances recommends using a saddle valve. Do not use self-piercing valve. Amana Appliances is not responsible for property damage due to improper installation or water connection. 1 /4" (6 mm) outside diameter flexible copper tubing*. Cover removal *Length of copper tubing must reach from water supply 6. Remove elect

ملخص المحتوى في الصفحة رقم 4

10. Replace upper vertical cover by placing cover on 18. Slide water fill tube extension over water inlet tube on refrigerator. Carefully tuck wires inside cover to avoid rear wall. Water fill tube extension must fit tightly and 1 pinching wires. Insert and tighten screws with a /4" be even with hole in rear wall so water cannot leak hex nut driver. into freezer. 11. Remove tape from end of copper tubing. Put end of copper tubing into sink or bucket. Slightly turn on water supply to refrigerator

ملخص المحتوى في الصفحة رقم 5

24. Built-In Models (SB******) 32. Create service loop using extreme care to avoid Remove and discard button plugs above ice maker kinks. Secure copper tubing with a “P” clamp with a putty knife covered with masking tape. and back horizontal cover screw. Copper tubing 3 All Other Models must not extend /8" (9 mm) beyond back. Remove and discard button plugs below ice maker A with a putty knife covered with masking tape. 25. Confirm stop pin locking fingers are unlocked. Center 1 drive pin must

ملخص المحتوى في الصفحة رقم 6

Before Calling For Service Allow ice maker 1 overnight period to make ice before assuming a difficulty exists. If ice maker is not producing ice • Confirm ice maker arm is down. • Confirm household water supply is reaching water valve. • Confirm ice maker wiring harness plug is completely inserted into electrical receptacle. • Check for kinks in copper or plastic tubing. Remove kinks or replace tubing. • Check electrical connections to water valve coil. • Confirm freezer is operating at proper

ملخص المحتوى في الصفحة رقم 7

7

ملخص المحتوى في الصفحة رقم 8

Part No. 10527037 Ó 1998 Amana Appliances Amana, Iowa 52204 Printed in U.S.A.