ملخص المحتوى في الصفحة رقم 1
™
Quasar Light and Return Water Flow for
Above Ground Pools Owners Manual
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Table of Contents
SECTION I. IMPORTANT SAFETY INSTRUCTIONS......................................................... 2
SECTION II. LAMP HOUSING INSTALLATION .................................................................. 2
SECTION III. ELECTRICAL CONNECTIONS FOR STORABLE POOLS ............................ 5
SECTION IV. ELECTRICAL CONNE
ملخص المحتوى في الصفحة رقم 2
SECTION I. IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following. 1. This light can be installed on storable above ground or permanent above ground pools. 2. A storable pool has a maximum water depth of 42 inches and is so constructed that it may be readily disassembled for storage and re-assembled to its original integrity. 3. A permanent pool has a maximum water depth over 42 inches. Do not
ملخص المحتوى في الصفحة رقم 3
NOTE Retain the gaskets supplied and keep them accessible. P U 3. Use the Teflon™ tape provided. Snugly wrap the threaded wall S H flange in a clockwise direction (as viewed from the back) starting at the edge of the threads; see Figure 2. Work towards the flange lip (overlapping 1/2 of the tape width with each wrap) then back towards the starting point. Bulb Retainer • If you have a new pool, move on to step 10. Figure 1. Nut • If the water level is below the return fitting on an existing pool,
ملخص المحتوى في الصفحة رقم 4
Figure 5. O-Ring—Use silicone Liner Flow Director lubricant only. Do not use Pool Wall Flange any petroleum lubricants. Body Bulb Assy. Nut Red Cap/Plug. (Bulb Assy.) Remove after bulb is in place in the Fitting Body. GASKET GASKET NOTE For narrow, interlocking, extruded aluminum wall panels, center flange between the ridges while viewed from the inside of the pool. Add the spacer and additional gasket to the flange before inserting the flange through the wall panel. This is necessary to accommo
ملخص المحتوى في الصفحة رقم 5
16. Now, from inside the pool, push the bulb assembly and flow director with the red cap/plug in place into the fitting body until the bulb assembly/flow director are nearly flush against the inside pool wall. 17. Thread the bulb assembly nut until it just touches the fitting body, then finger tighten. CAUTION Do not over tighten as adjustability of the flow director may be impaired and/or damage to parts causing leakage may occur. If the flow director does not rotate by hand, the nut is too tig
ملخص المحتوى في الصفحة رقم 6
¿¿¿WHAT IS A GFCI??? A ‘Ground Fault Circuit Interrupter’ is an electrical safety device designed to measure electrical leakage in a circuit. It is far more sensitive than a standard circuit breaker. GFCI equipped breakers and outlet combinations react to unsafe leakage and shut the power off before electrical shock injury can occur. Any electrical device used within 10 feet of a pool must be protected by a GFCI equipped outlet or a GFCI equipped circuit breaker and be intended for such use. SEC
ملخص المحتوى في الصفحة رقم 7
WARNING Press Together Do not attach or hang anything but this cord from the cord cap through the hole in the body to the transformer housing. Attaching or hanging items from this location can result in failure to the body or the pool wall which can result in serious personal injury and/or property damage. 5. Reinstall the snap-on cord cap to the stripped end of the cord leaving 1/4 inch black insulation protruding into the cap with Press Together the strain relief positioned as illustrated in F
ملخص المحتوى في الصفحة رقم 8
11. Place the junction box cover on the junction box bottom so that the junction box can more easily snap into the transformer box; see Figure 15. Snap the pieces together, then remove junction box cover. 12. Mount the transformer box on a pool support approximately 18 inches above the ground, in a position accessible to electrical connection; see Figure 16. To mount the transformer junction box, insert one of the screws provided, to a pool support. NOTE Do not install the transformer directly o
ملخص المحتوى في الصفحة رقم 9
SECTION V. RELAMPING INSTRUCTIONS WARNING Risk of electric shock. Disconnect power before servicing this unit. Failure to disconnect power can result in death or severe personal injury. 1. It is desirable to reduce the water level to the lower edge of the flow director. This makes bulb assembly replacement easier, but it is not mandatory. 2. Remove power from the unit by taking the power cord’s 3-prong plug and disconnecting it from its electrical outlet, or in the case of a hard-wired applicati
ملخص المحتوى في الصفحة رقم 10
8. Thread the bulb assembly nut until it just touches the fitting body, then finger tighten. CAUTION Do not over tighten as adjustability of flow director may be impaired and/or damage to parts causing leakage may occur. If low director does not rotate by hand, nut is too tight. 9. Take the red cap/plug off and gently bring the wire connectors through the back side of the bulb assembly. Save red cap/plug for storage and winterizing. 10. Connect the wire connectors from the bulb assembly to the w
ملخص المحتوى في الصفحة رقم 11
7. Remove the bulb assembly by pulling on the flow director while pushing the bulb assembly from the outside of the pool. NOTE The fitting body, threaded wall flange and gaskets may remain attached to the pool wall when winterizing, but should be removed if pool is to be stored. 8. For storable pools: remove the transformer from its mounting by lifting up and out. For permanent pools: cover the cord cap on the end of the flexible cord with a plastic bag and seal with a twist tie or rubber band.
ملخص المحتوى في الصفحة رقم 12
SAVE THESE INSTRUCTIONS. Pentair Water Pool and Spa, Inc. 1620 Hawkins Ave., Sanford, NC 27330 • (919) 566-8000 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 Visit us on the Internet at: www.pentairpool.com © 2004 Pentair Water Pool and Spa Incorporated. All rights reserved. Information in this document is subject to change without notice. Trademarks and Disclaimers. The Pentair Water Pool and Spa logo and Quasar are trademarks of Pentair Water Pool and Spa Incorporated. Ot
