Pitney Bowes Integra N300 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Scale
Installation Instructions
for the Integra™ N300 2-lb. Scale
Do not connect power until Step 10.
1
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaa
Make sure you have:
2

Scale

User Guide

Power Cord (in its own box)

Scale-Meter Interface Cable
(if ordered, packed separately)
Power Cord Scale-Meter Interface Cable
(if ordered, packed separately)
User Guide
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaa
Place your scale on a level
3
surface.

ملخص المحتوى في الصفحة رقم 2

Level the scale. Remove packing. 4 5 Bubble must be in center. Lift the platter, remove the Adjustable Feet (4) packing material, Level the scale by turning the scale feet until and replace the leveling bubble is centered and the scale the platter on the scale. does not wobble. aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaa Connect scale-meter interface Locate the plug ports. 6 7 cable to scale. Locate the plug ports If you're under the using a front of the scale Pit

ملخص المحتوى في الصفحة رقم 3

Result: The scale powers up and displays Plug power cord into outlet. 10 the LC (location code) prompt below. Go to Step 11 to continue. Note: If the scale does not power-up, check that the power cord is firmly attached. Also check that the wall outlet you are using has power by plugging in another device. aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaa Enter your location code. 11 Note: Your scale will not work unless you perform this step. a. Find the number corresponding

ملخص المحتوى في الصفحة رقم 4

Congratulations! You have successfully installed your Pitney Bowes electronic scale. If you have any questions about the initial setup, BE NEAR YOUR SCALE and call 1-800-537-2488 (menu option 1). Or visit our website at www.pitneybowes.com/ms_service/support/integra For information on using the scale, refer to the User Guide. *SV60424Rev.E* 4