ritetemp GPMG8010 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

50 60 70 80 90
50 60 70 80 90
Operation 8010
Once you have installed the
Temperature
thermostat, follow the instructions
Control
Low Battery
indicator below to operate your new
thermostat.
1 Configure
ï Set HEAT/COOL mode switch to
HEAT or COOL. Set the Fan
switch to AUTO (automatic).
2 Set Temp
Turn the Temperature control to
Thermometer
select the desired temperature.
HEAT/COOL
Fan
Mode Switch
Switch ï Warmer - to the right
Statement of use: The GPMG8010 can be u

ملخص المحتوى في الصفحة رقم 2

50 60 70 80 90 GAS ELECT 50 60 70 80 90 RC O RH B W Y G W2 A C 50 60 70 80 90 4 Heat Pump EMER Switch Circuit NOTE: If you have a HEAT PUMP with Board auxiliary heat this section applies to your system. If your Heat Pump malfunctions or cannot maintain your desired EMER latch temperature you may occasionally need to access the EMER position on the mode switch. This enables your auxiliary heat source and will continue until you turn it off. Gas/ Electric ju