ملخص المحتوى في الصفحة رقم 1
ELECTRIC OIL FILLED RADIATOR
INSTRUCTIONS FOR USE
SAVE THESE INSTRUCTIONS
RADIATEURS À BAIN D’HUILE
CONSIGNES D'UTILISATION
CONSERVER CES CONSIGNES
RADIADORES ELÉCTRICOS DE ACEITE
INSTRUCCIONES PARA EL USO
REPASE Y GUARDE ESTAS INSTRUCCIONES
LEA CUIDADOSAMENTE ESTE INSTRUCTIVO
ANTES DE USAR SU APARATO
TYPE/MODELO: EW7507EB/EW7507EBL
Register this product on-line and receive a free trial issue of Cook's Illu-
strated. Visit www.delonghiregistration.com.
Visit www.delonghi.com for a list of serv
ملخص المحتوى في الصفحة رقم 2
EN IMPORTANT SAFEGUARDS When using electrical appliances, basic precautions should always be taken to avoid the risk of fire, electric shock and personal injury, including the following: 1. Read all instructions before using this heater. 2. If your radiator is equipped with a polythene tape used as carry handle, remove it before connecting appliance to the outlet. 3. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handle when moving this heater. Keep
ملخص المحتوى في الصفحة رقم 3
extension cord or relocatable power tap (outlet/power strip). 20.Be sure that the plug is fully inserted into an appropriate outlet. Please remember that outlets also deteriorate due to aging and continuous use: check periodically if signs overheating or deformations are evidenced by the plug. Do not use the outlet and CALL your electrician. 21.Make sure that no pieces of polystyrene or other packaging material have been left between one element of the appliance and another. It may be necessary
ملخص المحتوى في الصفحة رقم 4
OPERATION AND USE 1) SETTING THE CLOCK For the first time, set the clock to the correct time, proceeding as follows: � Press the button “h” until the display shows the correct hour setting. � Press the button “min” until the display shows the correct minute setting. When setting the clock time, the numbers will flash on the display. The flashing numbers will continue for a few seconds until the adjustment has finished. Once the numbers stop flashing the clock will start working. To change the t
ملخص المحتوى في الصفحة رقم 5
ELECTRONIC CLIMATE CONTROL This heater has Electronic Climate Control (ECC) which automatically monitors and selects the ideal power setting to maintain your chosen temperature. If the selected temperature is higher than the actual room temperature, the appliance will start automatically and rapidly heat the room until it reaches the selected tempera- ture. The unit will automatically maintain the temperature at a constant level, by swit- ching between maximum, medium, minimum power and OFF. If
ملخص المحتوى في الصفحة رقم 6
- To set the program B press “Timer button B” and follow the same procedure as described for the program A. - Use the “ +” or “ -” buttons to set the desired comfort tempera- ture, as described above. - When set in this way the heater will automatically switch on at the set time for the designated time period and automatically maintain the fig. 3 preset comfort temperature. To cancel a preset program, press the timer button A or B once and then press the hour button until the display shows “
ملخص المحتوى في الصفحة رقم 7
WARNINGS You must leave the heater plugged into the outlet to keep the timer memory programmed. If the heater loses its power supply for more than 2 minutes, (e.g. switched off at the outlet or in the event of a power failure), the heater’s programs will be lost, and the heater will not work until reset. SAFETY DEVICE A safety device switches the heater off in the event of everheating. To restart the heater, call the nearest service center. Note: when the safety device intervenes, the heater do
ملخص المحتوى في الصفحة رقم 8
This warranty applies to all products with De’Longhi or Kenwood brand names. Limited Warranty What does the warranty cover? We warrant each appliance to be free from defects in material and workmanship. Our obliga- tion under this warranty is limited to repair at our factory or authorized service center of any defective parts or part thereof, other than parts damaged in transit. In the event of a products replacement or return, the unit must be returned transportation prepaid. The repaired or ne
