Dimplex DXLWP800 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation and Operating Instructions
INDUKLWPRG Issue 6
Dimplex Low Wattage Panel Heaters
Models: DXLWP400, DXLWP400TI,
DXLWP800, DXLWP800TI N & ARLWP800TI
Dimensions
600 mm - 400W
(millimetres)
800 mm - 800W
Models Specification
DXLWP400 400W Neon Heat Switch
DXLWP400TI 400W Neon Heat Switch / 24 Hour Timer
DXLWP800 800W Neon Heat Switch
500 mm
DXLWP800TI N 800W Neon Heat Switch / 24 Hour Timer
ARLWP800TI 800W 2 Neon Heat Switches / 24 Hour Timer
THESE INSTRUCTIONS SHOULD BE R

ملخص المحتوى في الصفحة رقم 2

Positioning the Heater 150mm 130mm 130mm 340mm - 400W Select the position for the heater ensuring there is clearance 540mm - 800W from any furniture and fittings of at least 150mm above the heater, 95mm 50mm below (wall mounted) and 25mm each side. Curtains must not be closer than 150mm from the top of the heater. Free Standing Operation (see Fig. 1) 420mm 25mm 25mm Drilling Holes NEVER USE THE HEATER FREE STANDING WITHOUT THE FEET FITTED (FEET ARE PACKED SEPARATELY IN CARTON). 1. Lay the heate

ملخص المحتوى في الصفحة رقم 3

11 11 12 12 13 13 14 14 15 15 Models with Timer DXLWP400TI, DXLWP800TI N & ARLWP800TI Set the I - - O slide switch on the timer (Fig. 3) to : I Position O - Heating Off Position I - Manual operation This setting allows power to the heater O uninterrupted by the timer settings. The heat selector switch will control the output (see ‘Using the heater’). Fig. 3 Position - ‘Auto’ operation DO NOT disconnect this heater from the mains supply unless it is being I taken out of use (e.g. in summ

ملخص المحتوى في الصفحة رقم 4

Cleaning WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER. Do not use detergents, abrasive cleaning powder or polish of any kind on the body of the heater. Allow the heater to cool, then wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean off stains. Be careful not to allow moisture into the heater. Recycling For electrical products sold within the European Community. At the end of the electrical products useful life it should not be disposed of w