ملخص المحتوى في الصفحة رقم 1
Owner’s
Manual
Ceiling Fan Installation Instructions
For 5EPR60BRD Series Fans
READ AND SAVE THESE INSTRUCTIONS
Total fan weigh
with light
ملخص المحتوى في الصفحة رقم 2
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70- 1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer. 3. After making the wire connections,
ملخص المحتوى في الصفحة رقم 3
7 8 9 Lift mounting neck to mounting Plate and align Secure mounting neck to the mounting plate Remove keeper from cross pin and with four screws to become a complete mount- screws. then cross pin from yoke. Replace ing bracket. keeper on cross pin and save. 10 11 12 Loosen lock nuts and screws on yoke Loosen set screw that holds ball. Slide ball down and remove pin save till you can not feel screw on inside pin for later. of yoke. 13 14 15 Install downrod into yoke. Align hole in downrod with
ملخص المحتوى في الصفحة رقم 4
19 20 21 Remote Transmitter Dip swtiches Remote Receiver Dip switches Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you Tighten set screw to hold ball in Place ball on downrod. Replace pin can set to control from one transmitter by setting both place. removed earlier and pull ball up so that receivers the same as the transmitter. If you have more than one fan with remote. Yo
ملخص المحتوى في الصفحة رقم 5
31 32 33 Twist lower cover plate into place by Loosen 3 screw on light plate as Plug white wire from fan to white twisting in direction of arrow. shown. wire from light kit. Then plug black Replace 1 screw removed and tighten wire from fan to black wire from light all 3 screws securely. kit. 34 35 36 Place light kit over screws and twist direction of arrow into place. Then Install 3 x 40 watt incandescent can- Install glass onto light kit, install tighten all 3 screws securely. delabra bulbs.
ملخص المحتوى في الصفحة رقم 6
Remote Control Transmitter Features: FAN REVERSE LED LIGHT (Press once to change direction of MEDIUM SPEED the fan)Fanmust be running to reverse. LOW SPEED HIGH SPEED FAN OFF SETTING LIGHT ON/OFF SET- (Turns fan off only) TING AND DIMMER (Press and hold to dim light infinitively) FAN SPEED Depress “l dot” for low speed, “2 dots” for medium or “3 dots” for high. To turn fan off press square”. LIGHT DIMMER To turn light on, press light dimmer once quickly. To turn off press once quickly while lig
ملخص المحتوى في الصفحة رقم 7
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleanin
ملخص المحتوى في الصفحة رقم 8
6/21/06 REV.0 New made from 5GMR manual
