ملخص المحتوى في الصفحة رقم 1
OWNER’S
MANUAL
Ceiling Fan Installation Instructions
Total fan weight
with light kit
For 5OR52XXD Series Fans
READ AND SAVE THESE INSTRUCTIONS
QUALITY CEILING FANS
ملخص المحتوى في الصفحة رقم 2
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes ANSI/NFPA 70-1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer. 3. After making the wire connections, the wires shoul
ملخص المحتوى في الصفحة رقم 3
C Ca an na ad diia an n m mo ou un nt tiin ng g o on nlly y 7 8 9 Safety Cable Lag Screw Lag Screw Safety Cable Washer Lock Washer Hang assembled fan from the mounting bracket For Canadian installation in both flush and down- installed to ceiling in previous step. Make sure the rod mode the safety cable must be installed into Make sure the studs protruding from the fan is hanging straight. Rotate fan until the tab on the house structure beams using the 3” lag screws bottom of the Mounting brac
ملخص المحتوى في الصفحة رقم 4
19 20 21 Hands free hook Remove the all thread studs from the lower part of the mounting bracket. Hang fan from mounting bracket by the hands Place canopy over fan body Replace the 3 screws removed and free hook into a closed hole on the aligning holes. tighten securely. Check motor for edge of the Canopy. Note: For shipping stabilizers and remove if Canadian mounting refer to Step #8. present. 22 23 24 Fan House Blue Black Black White White Green Ground Make wire connections to power source
ملخص المحتوى في الصفحة رقم 5
31 32 33 Locate blue and white wire from the fan marked “For light kit”. Connect blue from fan Tighten keeper nut onto threaded Install 3 x 60 watt Candelabra base to black from light and white from fan to white pipe from the light kit. bulbs. from light by pushing connectors together. 34 35 36 Attach switch cap to fan by lining up Remove finial nut, finial cap, hex nut, Install rubber washer and hex nut to 2 slot ear holes and 1 screw hole and and washer from fitter. glass tighten nut. twisti
ملخص المحتوى في الصفحة رقم 6
TROUBLE SHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleani
