Desa C26TU دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

C26TU and C26TO
Corner Mantel and Base
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Important: Read entire instruction sheet before If any wood pieces are missing or damaged, contact the
dealer where you purchased this mantel for replacement. If
assembling or installing mantel kit.
hardware is missing or damaged, contact DESA Heating, LLC
These mantels are only approved for use with any
at 1-866-672-6040 for referral information. You can also visit
DESA Heating, LLC 26" electric and gas fireplace

ملخص المحتوى في الصفحة رقم 2

ASSEmbLING mANTEL Right Leg Important : more than one person is required to lift Assembly 1 assembled mantel. Lift mantel by leg assemblies. Lifting 1 / " 4 #2 by header or mantel top could damage mantel. Screws Use the following illustrations to assemble mantel. Use only Left Leg screws provided. Assembly #3 1 1 / " Screws 4 Base #1 Base #1 Figure 3 - Installing mantel Base IMPORTANT: Align mantel left to right on base before installing. Corner of mantel legs must be flush with back of

ملخص المحتوى في الصفحة رقم 3

Fireplace Installation 1. Fireplace should be fully assembled. See Assembling Fireplace in fireplace owner’s manual. Mantel Top Assembly 2. Mantel must be installed flush with two walls. Remove baseboard along walls where mantel is to be installed. Baseboard will prevent proper installation of mantel and base. 3. Place mantel base close to installation location. See fire- Assembly place owner’s manual for installation clearances. Leave Blocks enough room to insert fireplace from back of m

ملخص المحتوى في الصفحة رقم 4

Electric Fireplace Installation mANTEL INSTALLATION 1. Carefully push mantel and base into position in corner This mantel can be used with DESA Heating, LLC electric and flush against both walls. Check operation of fireplace fireplaces. Electric fireplaces install from the front of mantel. before proceeding. To install electric fireplace see fireplace instruction manual. 2. Place right trim strip on right side of top and left trim on left Vertical Support Installation side of top. Align bot