Desa W23OT دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

W23OT ManTel and Base
asseMBl Y and InsT alla TIOn InsTRUCTIOns
Important: Read entire instruction sheet before Assembling mAntel
assembling or installing mantel kit.
WARning: Use only 1/2" screws to attach metal
this mantel is only approved for use with DesA
angle brackets. Damage to mantel will result if other
Heating, LLC 21" and 23" fireplace systems*. Do
screws are used for this purpose.
not use mantel with any other product.
imPORt Ant : more than one person is required to lift
*CGE

ملخص المحتوى في الصفحة رقم 2

1. Lay right side panel (#2) face down on a soft surface to avoid marking finish. Attach three brackets with 1/2" screws to bottom of right front leg (#3) leaving screws Header slightly loose. Face brackets out (see Figure 1). Place right front leg (#3) over right side (#2) as shown in Figure 2, paying close attention to direction arrow pointing up on panels. Align threaded holes with brackets on side. Start three 1/2" screws through brackets. Align bottom of side and leg assembly so the

ملخص المحتوى في الصفحة رقم 3

Att ACHING toP oF MANtEL GAS FIREPLACE INSt ALLAtIoN 1. Fireplace should be fully assembled. See Assembling 1. Place mantel top (#7) onto upright leg assembly (see Fireplace in fireplace owner’s manual. Figure 5). Align back of top with back of sides. 2. Place mantel base close to installation location. See 1 2. Using three 1 ⁄4" screws with washers, attach top to fireplace owner’s manual for installation clearances. header/leg assembly (see Figure 5). 3. Mantel must be installed flush wit

ملخص المحتوى في الصفحة رقم 4

DESA Heating, LLC 2701 Industrial Drive P.O. Box 90004 Bowling Green, KY 42102-9004, USA www.desatech.com 1-866-672-6040 121868-01 121868 01 Rev. B 08/07 NOT A UPC