Desa Wall Mantel with Base and Trim WS26CP دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

WS26CP and WD26CPA
Wall Mantel with Base and Trim
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Tools anditems required:
Important: Read entire instruction sheet before as-
1
sembling or installing mantel kit. • #2Phillips driver bit (3 /2" minimum length)
• Slotted screw driver
This mantel is only approved for use with any DESA
• Measuringtape
Heating Products 26" fireplace system. Do not use mantel
• Pencil
with any other product.
• Drill Driver
• Mantel pieces - unassemb

ملخص المحتوى في الصفحة رقم 2

4. Turn top (#7) and leg assembly upside down. Place leg ASSEMblING MANTEl assemblyinside top (see Figure5, page 3). Important : More than one person is required to lift 5. Make sure rear of leg assemblies are flush with back of assembled mantel. l ift mantel by leg assemblies. l ifting top and mantel is centered left to right inside top. Square by header or mantel top could damage mantel. leg assemblies evenly with sides of mantel top, making

ملخص المحتوى في الصفحة رقم 3

8. Place mantel assembly onto mantel base and center Mantel l e f t t o r i g h t w i t h b a c k o f a s s e m b l y fl u s h w i t h b a c k o f Assembly 1 base (see Figure 7, page 3). Use 1 /4" screws in pocket holes to attach mantel assembly to mantel base. Using brackets and 1/2" or 3/4" screws from this hardware kit (118983-01) attach support brackets to base and mantel assembly - one at each back corner of the

ملخص المحتوى في الصفحة رقم 4

L I P F F O L O 5. Place trim kit on the shoulder screws located on the INSTAllING FIREPlAcE side and top of the fireplace. Firmly snap the trim over 1. Fireplace should be fully assembled. See Assembling the shoulder screws on fireplace (see Figure 9). Align Fireplace in fireplace owner ’ s manual. fireplace in mantel assembly so that the trim overlaps 2. Install gas line. See Connecting To Gas Supply in