ملخص المحتوى في الصفحة رقم 1 
                    
                        Installation
 Instructions
Models:
WHB30, WHB33, WHB36, WHB42 
WTB30, WTB33, WTB36, WTB42
These refractories are intended for use with the Novus NDV and NBV Series gas appliances. Check with your local build-
ing code agency before you begin installation to ensure compliance with local codes, including the need for permits and 
follow-up inspections. If you encounter any problems regarding code approvals, or if you need clarifi cation of any of the 
instructions contained here, contact your Heart
                    
                    ملخص المحتوى في الصفحة رقم 2 
                    
                        1. Shut off the electricity to the appliance and turn the gas  Make sure to shorten the bracket if installing in a B-vent  shutoff valve to the closed position. See Figure 1. Remove unit. See Figure 4. the screen and glass from the appliance. Figure 1 - Gas Shutoff Valve Figure 4 Shorten Brackets for B-Vent Installation 2. If installing this refractory into a B-Vent Appliance, please  4. Set the back refractory piece into the brackets. See  go to “To Convert Refractory Kit to Fit B-Vent Applianc
                    
                    ملخص المحتوى في الصفحة رقم 3 
                    
                        5. If lava rock has been placed in appliance, clean the rock 7. To secure the side refractory in place, remove either the  away from the fi rebox sides to make room for the side middle or back screw in the fi rebox top. Attach a refractory  refractory. See Figure 7. bracket (using the screw removed) to the fi rebox top. See  Figure 10. Figure 7 Move Lava Rock to Install Side Refractory Figure 10 Attach Refractory Bracket 6. Carefully install a side refractory. See Figures 8 and 9. 8. Repeat Step 3 
                    
                    ملخص المحتوى في الصفحة رقم 4 
                    
                        12. Convert Refractory Kit to Fit B-Vent Appliance a. Locate the back refractory piece and lay the brick side down  on a fl at surface. Locate the indicator marks on the back  of the refractory piece. Lay a straight edge on the indicator  marks and cut with a utility knife. See Figure 8. Figure 8  b. B-Vent/Herringbone - cut at line, discard lower (smaller)  portion. Install cut side down. Refer to Figure 9. c. Direct Vent/Herringbone - Install whole refractory. (back of Herringbone refractory) (