ملخص المحتوى في الصفحة رقم 1
See-Thru wood Burning
Fireplace
owner’S opera Tion and
inSTalla Tion Manual
Models (V)3612ST
SAVE THIS BOOK
This book is valuable. In addition to instructing you
on how to install and maintain your appliance, it also
contains information that will enable you to obtain re-
placement parts or accessory items when needed. Keep
it with your other important papers.
This fireplace is approved for use as a wood burning fire-
place or for use with a vented gas log approved to ANS
Z21.60 or Z21.84
ملخص المحتوى في الصفحة رقم 2
WARNING: Improper installation, adjustment, altera- tion, service or maintenance can cause injury, property damage or loss of life. Refer to this manual for assis- tance or additional information. Consult a qualified installer or local distributor. TaBle oF conTenTS Safety Information ............................................... 2 Optional Gas Line Installation............................ 12 Product Dimensions ............................................ 3 Operation and Maintenance Guidelin
ملخص المحتوى في الصفحة رقم 3
SaFeTy WARNING: Always leave Continued glass doors fully opened or fully closed when operating WARNING: Use solid wood fireplace. or processed solid fuel fire logs only. When processed wood WARNING: Children and fuel fire logs are used, do not adults should be alerted to the poke or stir the logs while they hazards of high surface tempera- are burning. Use only fire logs tures and to stay away to avoid that have been evaluated for burns or clothing ignition. Young the applicatio
ملخص المحتوى في الصفحة رقم 4
1 43 /4" (109.8cm) Fireplace inST alla Tion Spacers on Sides of Fireplace SELECTING LOCATION 2" (5 cm) Min. Clearance Provide Required 1" (2.5 cm) From Pipe to Combustibles Clearance To determine the safest and most efficient location for the fireplace, you must take into consideration the following guidelines: 1. The location must allow for proper clear- ances (see Figure 2). 2. Consider a location where the heat output will not be affected by drafts, air condition- ing ducts, windows or do
ملخص المحتوى في الصفحة رقم 5
5 44 /8" (113.3cm) 7 53 /16" (135.7cm) MIN. AS REQUIRED BY DESIGN AS LONG AS CEILING CLEARANCE IS MAINTAINED Fireplace inSTalla Tion Continued 2. If fireplace is to be installed directly on carpeting, tile (other than ceramic) or any combustible material other than wood flooring, fireplace must be installed upon a metal or wood panel extending full width and depth of fireplace. 3. Set fireplace directly in front of opening and slide unit back until nailing flanges touch side framing. 4. C
ملخص المحتوى في الصفحة رقم 6
8" MIN. (20.3cm) 1 36 /2" MIN. (92.7cm) 1 52 /2" MIN. (133.3cm) Fireplace inST alla Tion Continued the front face must not be placed within 9" of fireplace opening. Combustible materials above and projecting 1 more than 1 /2" from the fireplace front face (see Figure 11) must not be placed less than 12" from effective opening of the fireplace (NFPA STD 211, Sec. 7-3.3.3). Mantels or any other combustible material may also come up to the side edge of the black metal face of the fireplace
ملخص المحتوى في الصفحة رقم 7
PIPE INSTALLATION VenTing inST alla Tion The pipe sections must be assembled inde- Continued pendently as the chimney is installed. When Secure to Collars with connecting chimney directly to the fireplace, Duct Tape or Screws the inner flue pipe section must be installed first with the lanced side up. The outer pipe section Air Inlet can then be installed over the flue pipe section Location with the hemmed end up. Press down on each Must Allow pipe section until the lances securely engage
ملخص المحتوى في الصفحة رقم 8
2" (5.1cm) VenTing inST alla Tion Minimum Continued Maximum length of pipe between supports Angled Firestop is 6' of angle run. Maximum of two 6' angle 2" (5.1cm) run sections per chimney system (see Figure Minimum 9, page 8). Ceiling 12S-12DM Support Support Required Straps 30 FT. 30 FT. Return (9.14m) (9.14m) Elbow Figure 17 - Chimney Supports RETURN ELBOW RETURN Return ELBOW Elbow 6' MAX (15.2cm) 6' MAX CEILING Figure 15 - Elbow Offset (15.2cm) SUPPORT PIPE OFFSET OFFSET RISE CHIMNEY
ملخص المحتوى في الصفحة رقم 9
Uncommon circumstances such as neigh- VenTing inST alla Tion boring hills, tall trees, or strong wind areas Continued can cause down drafts in chimney system. Existing In such cases, going beyond the minimum Ceiling recommended height would be preferable to Frame provide a better draw. The fireplace height approved for any chim- Firestop ney run with this fireplace system is 40 feet Spacer measured from bottom of fireplace to flue Screws or outlet-end of pipe (see Figure 22). Staples (M
ملخص المحتوى في الصفحة رقم 10
Storm VenTing inST alla Tion Overlap Collar Continued Shingles Top Flashing and Sides Only PENETRATING ROOF Cone To maintain a 1" clearance to pipe on a roof with Nail Only a pitch, a rectangular opening must be cut. Outer Perimeter 1. Determine the center point through which of Flashing pipe will penetrate roof. 2. Determine center point of roof. Pitch is the distance the roof drops over a given span, usually 12". A 6/12 pitch means that the roof drops 6" for each 12" one measure ho
ملخص المحتوى في الصفحة رقم 11
FINISHING FIREPLACE VenTing inST alla Tion Combustible materials, such as wallboard, Continued gypsum board, sheet rock, drywall, plywood, RTL-12D Stainless etc. may make direct contact with sides and Inner Flue Chase top around the fireplace face. It is important Pipe Top that combustible materials do not overlap the Screen face itself. Brick, glass, tile or other noncom- bustible materials may overlap the front face provided they do not obstruct essential open- 1" ings like louvered s
ملخص المحتوى في الصفحة رقم 12
opTional a g S line inST alla Tion refractory cement or commercial furnace WARNING: A qualified cement, Install the gas appliance or cap off gas line if desired. service person must connect fireplace to gas supply. Follow CAUTION: All gas piping all local codes. and connections must be tested NOTICE: Before you proceed, make sure your for leaks after the installation gas supply is turned off. is completed. After ensuring A gas line may be installed for the purpose that the gas valve
ملخص المحتوى في الصفحة رقم 13
oT p ional gaS line inST alla Tion Continued WARNING: Do not oper- WARNING: When using a ate an unvented gas log set in decorative vented gas log, the this fireplace with the chimney damper must be removed or per- removed. manently locked in the fully open position and the glass doors must be in the fully open position. WARNING: If the fireplace has been used for wood burning, Note: An appropriate DESA Heating, LLC the firebox and chimney must be hood (see Replacement and Accessory
ملخص المحتوى في الصفحة رقم 14
opera Tion and MainTenance uideline g S Continued ways open mechanism when starting a fire. DAMPER MECHANISM This provides adequate outside combustion The damper control lever is located inside the air. Close mechanism when not in use to fire chamber (see Figure 32). Make sure lever prevent cold air from entering room. Periodi- is cool before handling. Pull down to close and cally check your outside air intake vent hood push up to open. Damper must be open when for any possible obstructi
ملخص المحتوى في الصفحة رقم 15
replaceMenT and a cceSSory p ar TS ADjUSTABLE HOOD Black - 01244 Brass - 01245 Chrome - 01246 Vent Plaster Vent Hood Collar GRATE, 10" Connector 11169 Duct - 4" x 3' OUTSIDE AIR KIT - AK4 EMBER STORM COLLAR - SC2-1 PROTECTORS (2) 20093 FIRESTOP SPACER FS-10 for Straight Pipe 30FS-10 for 30° Angled Run DOUBLE WALL PIPE - 12-12DM, 18-12DM, 24-12DM, 36-12DM, 48-12DM FLASHING V6F-10DM 0 to 6/12 (Chimney pipe assembly includes outer and inner pipes and comes with wire Pitch spacer.
ملخص المحتوى في الصفحة رقم 16
DESA Heating, LLC 2701 Industrial Drive Bowling Green, KY 42101 www.desatech.com 1-866-672-6040 115603-01 Rev. C 115603 01 12/08 NOT A UPC
