American Standard Savona 2901.XXXW دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

SAVONA™ 2901.XXXW
SERIES WHIRLPOOL
HIGH GLOSS ACRYLIC
SHOWN LESS ALL FITTINGS
INSTALLATION INSTRUCTIONS
1810mm
19mm
(71-1/4)
(3/4)
SAFE-T-HEATER
905mm
TYP.
REMOVABLE
(35-5/8)
BLANK
ON/OFF
THANK YOU...
SWITCH
for selecting an American Standard bath. Your new
552mm
PUMP
1105mm
(21-3/4)
bath is shipped to you after careful inspection. The
OUTLINE OF
(43-1/2)
1772mm X
C/L whirlpool version is completely assembled with pump,
1067mm
(69-3/4 X 42)
motor, and system piping. All you need to finish

ملخص المحتوى في الصفحة رقم 2

INSTALLATION AND FRAMING INSTRUCTIONS The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs as required. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for access to the drain components. 1. Position the whirlpool into the installation ope

ملخص المحتوى في الصفحة رقم 3

ELECTRICAL INSTALLATION INSTRUCTIONS All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes. WARNING: When using electrical products, basic precautions should always be observed, including the following: 1. DANGER: RISK OF ELECTRIC SHOCK Connect only to a circuit protected by a ground-fault circuit interrupter. 2. Grounding is required. The unit should be installed by a licensed electrician and grounded. 3. Install

ملخص المحتوى في الصفحة رقم 4

WIRE SELECTION GUIDE Maximum distance from The sizes shown on this fusebox to motor chart are recommendations Motor 50' 100' 150' 200' for copper conductors Hi Performance only. Always follow Rating 120V Power Line local and national electrical codes 2.1 12 10 8 8 DRAIN CONNECTION AND SYSTEM TEST Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the pump couplings and make sure they are hand-tight. Clean the whirlpool and fill