ملخص المحتوى في الصفحة رقم 1
¨
Model No. IMHS80081
Serial No.
Write the serial number in the space
above for reference.
Serial Number Decal
QUESTIONS?
As a manufacturer, we are com-
mitted to providing complete
customer satisfaction. If you
have questions, or find that there
are missing or damaged parts,
we will guarantee complete satis-
faction through direct assistance
from our factory.
TO AVOID UNNECESSARY
DELAYS, PLEASE CALL DIRECT
TO OUR TOLL-FREE CUSTOMER
HOT LINE. The trained techni-
cians on our customer hot line
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS LIMITED WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 BEFORE YOU BEGIN . . . . . . . . . . . . . . . .
ملخص المحتوى في الصفحة رقم 3
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of drowning, electric shock, or serious injury, read the following important precautions before using the hydrotherapy spa. READ AND FOLLOW ALL INSTRUCTIONS 1. It is the responsibility of the owner to ensure must be maintained as explained in this man- that all users of the hydrotherapy spa are ual (see page 13). Failure to do so may cause adequately informed of all precautions. injury to users or damage to the spa jet unit, and will void
ملخص المحتوى في الصفحة رقم 4
motor of this unit to connect a minimum No. the unborn child could be seriously harmed. 2 8 AWG (804 mm ) solid copper conductor between this unit and any metal equipment, 28. DANGERÑTo reduce the risk of drowning: electrical enclosure made of metal, metal Prolonged immersion in the hydrotherapy water pipes, or conduit within five feet spa may cause hyperthermia, a dangerous (1.52m) of the unit. condition which occurs when the internal body temperature rises several degrees 22. DANGERÑRisk of e
ملخص المحتوى في الصفحة رقم 5
WARNING LABEL IDENTIFICATION The warning labels shown below have been placed on the spa cover, printed inside the inflatable spa liner, and placed on the side of the spa jet unit of the hydrotherapy spa. Locate the labels and familiarize yourself with this information. The label on the side of the spa jet unit is an adhesive decal. If this decal is missing, or if it is not legible, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m.
ملخص المحتوى في الصفحة رقم 6
BEFORE YOU BEGIN ¨ Thank you for selecting the IMAGE RENEW 800. The Department toll-free at 1-800-999-3756, Monday innovative RENEW 800 offers the features and quality through Friday, 6 a.m. until 6 p.m. Mountain Time of a traditional hot tub at an affordable price. Best of (excluding holidays). To help us assist you, please all, the RENEW 800 is fully portable, so you can take note the product model number and serial number it wherever there is an electrical outlet. The RENEW before calling. Th
ملخص المحتوى في الصفحة رقم 7
CHOOSING A LOCATION FOR THE HYDROTHERAPY SPA There are many factors to consider when choosing a location to set up the hydrotherapy spa. These factors vary depending on whether you use the hydrotherapy spa inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the hydrotherapy spa. If you set up the hydrotherapy spa inside: If you set up the hydrotherapy spa outside: 1. The hydrotherapy spa will increase the level of 1. You should check yo
ملخص المحتوى في الصفحة رقم 8
ASSEMBLY Before beginning assembly, carefully read the ¥ Assembly requires the included air pump. following information and instructions: ¥ Read each assembly step before you begin. ¥ Place all parts in a cleared area and remove the packing materials; do not dispose of the packing ¥ During assembly, make sure that all parts are ori- materials until assembly is completed. ented as shown in the drawings. ¥ Assembly requires two people. 1. Before beginning assembly, be sure that you 1 have read a
ملخص المحتوى في الصفحة رقم 9
4. Remove the power cord from the Spa Jet Unit (13). 4 With the help of a second person, place the Spa Jet 13 Unit (13) over the Side Panel (1) and the section of the Inflatable Spa Liner (9) which does not have the cushion. Be extremely careful not to tear the Inflatable Spa Liner (9) as you slide the Spa Jet Power Unit into place. Cord 9 1 5. Before you fill the hydrotherapy spa, be sure that it 5 9 is in the position you want, and that it can be easily serviced, if needed. Once the hydrothera
ملخص المحتوى في الصفحة رقم 10
7. Place the Spa Cover (11) over the Side Panels (1, 7 2) and the Spa Jet Unit (13). Be sure that the Spa 11 Cover is properly centered and that the straps on the Spa Cover line up with the straps extend- ing from the slots in the Side Panels (1, 2). Snap each of the six latches on the Spa Cover (11) into the buckles on the straps extending from the slots in the Side Panels (1, 2). 13 1, 2 Latches and Buckles USING THE HYDROTHERAPY SPA The hydrotherapy spa is designed for up to four adults. The
ملخص المحتوى في الصفحة رقم 11
STARTING THE HYDROTHERAPY SPA If the level is too low, add half of one of the ÒQUICK pHix It UPÓ packets to the water. Let the water circu- Once you have tested the GFCI, you should verify the late through the spa jet unit for five minutes. Test the water flow from the pumping unit. Set the air control pH level again. Repeat until the pH level is correct. on the console to the lowest setting (see USING THE CONSOLE on the next page). The pumping unit will If the level is too high, add half of one
ملخص المحتوى في الصفحة رقم 12
DIAGRAM OF THE CONSOLE USING THE CONSOLE 70¡F to 104¡F. Use a medical or other accurate ther- mometer to check the temperature of the water. Refer to the console diagram above. The function of each console control is explained below: On/Off: Turns the spa jet unit on and off. When you first press the on/off button, the spa jet unit will run at Primer: This opening allows you to prime the spa jet low speed, providing gentle hydrotherapy. Press the unit before operation (see PRIMING THE SPA JET bu
ملخص المحتوى في الصفحة رقم 13
ment by removing the filter cover and the two filter hose to siphon the water. Place one end of the hose in cover screws and then pulling the filter from the spa jet the spa and hold it in front of a hydrotherapy jet until unit. there is a flow of water coming out of the hose. Turn off the spa unit and unplug the power cord. The The spa jet unit features an automatic filter cycle and unit will be damaged if it is run without water cir- freeze protection. If the spa jet unit has not been oper- cu
ملخص المحتوى في الصفحة رقم 14
lines when handling the chemicals: tation agents in the water will not be effective if the pH 1. Always read and follow the directions on level is not properly maintained. Damage caused by the label, unless directed otherwise. improper pH levels is not covered under the warranty. 2. Never mix different chemicals. 3. Keep all chemicals out of the reach of chil- To maintain the proper pH level, you should test the dren and pets. pH of the water regularly. To test the water you can 4. Do not exceed
ملخص المحتوى في الصفحة رقم 15
b. The pump may have a bad bearing. Contact b. This problem is caused by excess air in the our customer service department. pump circulation system. Check to see if the primer cap is fully tightened. Prime the pump 6. SYMPTOM: THE WATER DOES NOT HEAT again and fully tighten the primer cap (see PRIMING THE SPA JET UNIT on page 10). a. The heater is attached to the pump in the spa jet unit. If the pump is operating, the water 10. SYMPTOM: THE SPA JET UNIT CONTINUES should heat. Cover the hydrother
ملخص المحتوى في الصفحة رقم 16
ORDERING REPLACEMENT PARTS To order replacement parts, simply call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). To help us assist you, please be pre- pared to give the following information when calling: 1. The MODEL NUMBER of the product (IMHS80081). ¨ 2. The NAME of the product (IMAGE RENEW 800). 3. The SERIAL NUMBER of the product (see the front cover of this manual). 4. The KEY NUMBER and DESCR
ملخص المحتوى في الصفحة رقم 17
PART LISTÑModel No. IMHS80081 R0399A Key No. Qty. Description Key No. Qty. Description 1 1 Side Panel 33 1 Rubber Damper 2 1 Rubber Grommet 34 1 Wire Harness 3 1 Dual Temperature Probe 35 1 Air Control Knob 4 1 Support Ball 36 1 On/Off Switch Assembly 5 4 #8 x 5/8Ó Screw 37 1 Thermostat Knob 6 2 Removable Collar 38 1 Primer Cap 7 4 1/4Ó x 1 1/2Ó Bolt 39 15 #8 x 1/2Ó Screw 8 1 Fabric Spa Surround 40 1 Console Overlay 9 1 Inflatable Spa Liner 41 1 On/Off Wire Harness 10 4 Fixed Jet 42 2 #10 x 1Ó S
