Precor c944 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

COMMERCIAL PRODUCTS DIVISION
Precor Handrail Option Kit
Fits Precor C944, C942, C940, M9.45, M9.41s Treadmills
Thank you for purchasing the Precor Handrail Option Kit. Each kit comes
complete with all the hardware required to install a handrail on one side of the
treadmill. If you wish handrails on both sides of the treadmill, you must order two
(2) option kits. When you receive the Handrail Option kit, check its contents with
the list below:
Note: If you purchase both handrails, check the conte

ملخص المحتوى في الصفحة رقم 2

COMMERCIAL PRODUCTS DIVISION Diagram 1 Installing the nut plate into the guide rail. End cap Bolt Finger guard Rear roller Side rail Guide rail Nut plate 1. To properly mount the lower handrail clamp, you need to install a nut plate into the guide rail. Remove the end cap from the rear of the treadmill using a Phillips head screwdriver. See Diagram 1. Important: If you are installing both handrail options, avoid misalignment of the finger guard by sliding the nut plate into position on one side

ملخص المحتوى في الصفحة رقم 3

COMMERCIAL PRODUCTS DIVISION 4. Place the center clamp on the front portion of the handrail, followed by an end clamp. See Diagram 2. Align the two clamps with the handrail mounts on the upper frame. 5. Insert a bolt through each clamp. See Diagram 2. Using the supplied 3/16" hex key, screw each bolt through the handrail until the clamp is snug against the upright support. Do not fully tighten the bolts until you have installed the lower end of the handrail. Diagram 3 Attaching the lower handrai

ملخص المحتوى في الصفحة رقم 4

COMMERCIAL PRODUCTS DIVISION f. To secure the handrail inside the clamp, use the 5/32" hex key provided. Do not overtighten the bolt or damage may occur to the clamp. Note: After extensive use, vibrations from the treadmill may cause the bolts to loosen. You may need to periodically inspect the bolts and, if necessary, tighten both the upper and lower handrail clamp bolts using the hex keys provided. g. Return to the upper handrail clamps and securely tighten the bolts using the 3/16" hex key. N