ملخص المحتوى في الصفحة رقم 1
®
Panama owner’s Manual
read aNd Save TheSe INSTrUcTIoNS!
Safety and the proper operation of your Casablanca fan both require a thorough knowledge
of the product and proper installation; therefore, before attempting to install and operate your
Casablanca fan, read this owner’s manual completely and carefully. Retain this manual for
future reference.
CautIoN: t o avoid possible electrical shock, make certain that electricity is turned off
at the circuit breaker or fuse box before attempting a
ملخص المحتوى في الصفحة رقم 2
pleaSe INSpecT all packaGING prIor T o dIScardING! Your Casablanca fan was crafted with pride and care and inspected thoroughly prior to shipment. Before you begin to assemble and install your Casablanca Always turn power to the ceiling fan OFF before re- fan, remove all parts from the carton and placing lightbulbs or working on your fan. check them against the Parts Guide in this Never insert anything into the path of the fan blades manual. while the fan is in operation. Never install a
ملخص المحتوى في الصفحة رقم 3
Panama ® Parts Guide Item # Description Picture (not to scale) Quantity 1. Motor Housing 1 2. Ceiling plate 1 3. Phillips Screwdriver 1 1 4. 1 /2" x 8-32" Roundhead screws and Washers , 2 EA Screw Pack: 5. 1 EA Lag Screw and Washer (1) 6. Wire Nuts (4), 4 7. 1 Canopy and Canopy Hatch Perma•Lock™ Downrod 8. 1 and Ball Assembly 9. 5 EA Canopy Screws and Lock Washers, 10. 1 Allen Wrench 3
ملخص المحتوى في الصفحة رقم 4
Item # Description Picture (not to scale) Quantity 11. Blade Irons 5 12. Blade Iron Screws 11 13. Blade Screws and Washers 16 EA Light Pull Chain Switch (G model only) 14. 1 2 -(66xxG) 15. Light Pull Chain Fandangle (G model only) 3 -(66DxxG) 16. 1 W-41 Single Rotary (optional for G model only) 17. W-81 Dual Rotary (optional for G model only) 1 ` 18. 1 W-85 Control and Mounting Hardware (Z model only) 4
ملخص المحتوى في الصفحة رقم 5
Panama ® introduction Before Yo U STar T • CAUTION: RISK OF ELECTRICAL SHOCK! Installation is to be in accordance with the National Electrical Code, ANSI/NFPA 70-1999 and local codes. If you are unfamiliar with the wiring codes, you should use a qualified electrician. To avoid overheating and possible damage to other equipment, do not install control to a receptacle, fluorescent light fixture, motor-operated appliance, or transformer-supplied appliance. • This fan is designed to be installe
ملخص المحتوى في الصفحة رقم 6
Mo UNTING re Co MMeNDaTIo NS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. support brace We suggest you follow these mounting recommendations as you decide where to install your Casablanca fan. • For safety reasons, the fan blades must be a minimum of 7' above the flo
ملخص المحتوى في الصفحة رقم 7
Panama ® f a N INSTa LLaTIo N GeTTING STar TeD Installing a New Ceiling Fixture Outlet Box Using Existing Ceiling Fixture Outlet Box If you do not have an existing fixture located where After turning the power OFF at its source (either you wish to place your Casablanca fan, an ap- the circuit breaker or fuse box), lower the old fixture proved ceiling fixture outlet box must be installed and disconnect the wiring. Check the ceiling fixture and wired. outlet box to be sure it is marked “Approve
ملخص المحتوى في الصفحة رقم 8
La G SCrew INSTa LLaTIo N (o PTIo Na L) NOTE: This step is required only under two condi- tions: If the fan weighs 36 lbs. or more (which does not pertain to this fan) or if the existing ceiling fixture outlet box needs to be modified for a ceiling fan application (for example, if the house is not new construction and you are replacing an existing light fixture). We recommend that the ceiling box be of sufficient capacity to support the weight of the fan and light fixture under any condi
ملخص المحتوى في الصفحة رقم 9
Panama ® Ca No PY Har Dware Ca No PY SCrew (5) Ca No PY Lo Ck wa SHer (5) Ca No PY HaTCH Ca No PY Ca No PY INSTa LLaTIo N Step 4. a ttach the canopy to the crossbar mounting bracket with three of 1 the 8-32 x 2 /2” long canopy screws and lock washers provided with your Casablanca fan. Hand tighten until snug against the ceiling. Note: on sloped ceilings, align the canopy opening toward the top or peak of the room. Ca No PY Lo Ck wa SHer fee D o UTLeT Bo X w Ire S THro UGH Ca No PY o PeNIN
ملخص المحتوى في الصفحة رقم 10
Ca No PY eLeCTr ICa L Co NNeCTIo NS Step 6a. a ttach the fan wires to the ceiling fixture outlet w Ire NUT w-85 Co NNeCTIo NS box wiring by twisting the bare ends of the wires together and then securing with a wire nut. Test that the connection is secure by pulling on the wire nut. Connect in this order: Step 6b. w-85 wiring Connections 2 BLa Ck • GreeN leads from mounting plate and fan to GroUNd conductor of power source. Secure with wire nut. • whITe wire from fan to white NeUTral wire in
ملخص المحتوى في الصفحة رقم 11
Panama ® blade/blade Holder inST alla Tion Step 10. a ttach the blades to the blade holders with the three blade screws and flat washers provided for each blade. Hand tighten securely. Install the assembled blade and blade holder to the fan motor. Hand tighten securely. BLa De SCrew r epete for each blade assembly. (3 Per BLa De) f LaT wa SHer (3 Per BLa De) BLa De Ho LDer SCrew (2 Per BLa De Ho LDer ) war NING: To reduce the risk of personal injury, do not bend blade holders when installing
ملخص المحتوى في الصفحة رقم 12
R 4-SPeeD o Pera TIo N Pull-chain switches on the fan control the fan and lights. o PTIo Na L LIGHT fa N & SPeeD Co N- Using the fan control pull-chain switch: f an off at start. PULL CHa IN Tro L f irst pull: fan oN, High speed Sw ITCH PULL CHa IN Sw ITCH Second pull: Medium speed Third pull: Medium Low speed f ourth pull: Low speed f ifth pull: f an off Using the optional light pull-chain switch: Light off at start. f irst pull: light oN re Ver Se Second pull: light off Sw ITCH Direct
ملخص المحتوى في الصفحة رقم 13
R 4-SPeeD Panama ® 4-Speed • w -41 wall co NTrol o F The Fa N • The w-41 allows the choice of four (4) different speed settings. • No light fixture is used. • Set the FaN pull chain switch to the HIGH speed setting. • No changes in household or fan wiring are required. • The fan may be turned o N and o FF by the w-41 wall control. CaUTIoN! f ailure to set the pull-chain speed to HIGH can result in faulty operation of the fan and damage to the w-41 wall control. To confirm fan is set to
ملخص المحتوى في الصفحة رقم 14
® 3 W-85 CoNtroL INStaLLatIoN WALL CONTROL AND HARDWARE (not to scale) (4) Wire Cap Wall Plate W-85 Switch Bezels Switch Mounting Screws White Wall Almond Wall Wall Control (1) White Screws (2) (2) White Plate(1) Plate(1) (1) Almond (2) Almond warNING! BEZEL To avoid possible electrical shock, make cer- tain that electricity is turned off at the circuit breaker or fuse box before attempting any in- stallation or repair procedure CAUTION! NOT turning the power OFF at the circuit breaker or f
ملخص المحتوى في الصفحة رقم 15
® 3 W-85 Wall Control Bezel replacement: - ALMOND CoNtINueD BEZEL Step 17c � Reinstall the rubber key pad on to the four (4) locating pins located on the almond bezel as shown in Figure #3 and #4. RUBBER KEY PAD figure #3 RUBBER KEY Step 17d � To attach the bezel back on to the front PAD of the switch you will need to align the four (4) tabs on the bezel with the front of the wall control and by gently pressing on both top and button of the bezel at the same time, snap the bezel back on
ملخص المحتوى في الصفحة رقم 16
® 3 W-85 CoNtroL INStaLLatIoN INSTallING The w -85 wall coNTrol ® Note: W-85 Wall Control should only be installed on Casablanca's Inteli-Touch 3 fans with DOWNLIGHTS ONLY. The wall control installs in the same manner as an ordinary light switch, using an existing wall box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed: 3. Do not use more than one fan per wall c
ملخص المحتوى في الصفحة رقم 17
® 3 DUa L w -85 INSTa LLaTIo N dIp SwITcheS To control the fan and lights from two locations (a three-way circuit), use two W-85 wall controls as shown in the wiring diagram in Figure #5. Before installing the two switches into the wall, place both switches side by side, then locate the 4 dip switches on the side of the two switches. Then make sure that the dip switches are set to the same address on both switches as shown in Figure #4. When setting these dip switches you are setting the c
ملخص المحتوى في الصفحة رقم 18
® 3 oP era TIo N Power The button is normally left in the on position. Always turn the power off during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs. The button must be left on to retain a previously set fan speed or light level. oP era TIo N SPeeD Co NTro L There are six individual speed settings for the fan; each speed is indicated by an audible tone of increasing pitch. FAN CONTROL To select the desired fan speed: ON - OFF:
ملخص المحتوى في الصفحة رقم 19
® 3 CHa NGING freq UeNCY SeTTING DIP NOTE: All fans leave the factory set to SwITcheS “1111” You will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately. NOTE: DO NOT set dip switch setting in the remote to ‘0000’, this may cause frequency interference from other Casablanca Products. Step 1. Turn power OFF at the circuit breaker or fuse box and at the toggle switch, for the fan you want to cha
ملخص المحتوى في الصفحة رقم 20
® 3 ® ® oP era TIo N Safe- eXIT a ND LIGHT-MINDer Pro Gra M Note: Both Light-Minder and Safe-Exit programs will always run at the same time. The Safe-exit Program gives you about thirty seconds of light when you turn the lights off, enabling you to exit your home before the lights go out. To enter the Safe- Safe-Exit Exit Program: 1) To operate the lights for Safe-Exit Program – Press the button off for at least five seconds. 2) Turn the Power on. Immediately press the buttons in the foll
