Harley-Davidson BFR550 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTRUCTIONS
-J01588 REV. 3-2-00
®
Kit Number 91578-00
V-LOGO TURN SIGNAL INDICATOR FOR ROAD KING
General
i02098.eps
Clamp
Fork Lock
Shroud
This kit is designed for installation on 1994 and later FLHR
Plate
Screws
(Road King) Model Motorcycles.
QTY DESCRIPTION PART No.
2 Cable strap 10065 Handlebar
2 Screw, machine panhead 2589 Clamp
3 Connector, butt 70585-93 Shroud
Chrome
Strip
1WARNING
Read all applicable Service Manual instructions before
beginning. If any procedures are not within your
capa

ملخص المحتوى في الصفحة رقم 2

i02099. eps i03000.eps Drill Hole Locations Turn Signal Connector and Wiring Pull Conduit Back to expose wires Figure 3. Headlamp Nacelle Figure 2. Handlebar Clamp Shroud 23. Following instructions in Service Manual under “Sealed 16. Insert wiring through hole and route under handlebar Butt Splice Connectors”, splice the wiring from the V- into the headlamp nacelle. Fasten V-logo to shroud logo to the left and right turn signal wires and to ground. cover using two panhead screws. Tighten securel

ملخص المحتوى في الصفحة رقم 3

i03035.tif Drill Template NOTE These marks should measure exactly 1 inch in each direction. Please measure to verify that this template is the correct size. 3 of 3 -J01588