Makita 4390DW دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

CORDLESS RECIPRO SAW Model 4390D (MCP)
Model 4390DW(MCP)
Item Part No. Item Part No.
No. No. Used Description No. No. Used Description
1 1 Motor D.C. 9.6V (With Item 16) 15 1 Housing (L)
* *
2 152272-4 1 Supporter Com. 16 1 Spur Gear 15
*
3 1 Gear Com. 17 231390-2 1 Compression Spring 3
*
4 253307-5 3 Thin Washer 4 18 414169-8 1 Lock-Off Lever
5 253874-0 1 Flat Washer 4 19 643909-9 1 Battery Holder 20
6 212014-9 1 Needle Bearing 407 20 41

ملخص المحتوى في الصفحة رقم 2

Item Part No. Item Part No. No. No. Used Description No. No. Used Description Accessories A03 783201-2 1 Hex Wrench 3 A04 DC9710 1 Fast Charger For 7.2V & 9.6V Ni-Cad A01 632007-4 1 9.6V Ni-Cad Battery 9000(1.3Ah) 1.3Ah Batteries A02 792542-5 1 Recipro Saw Blade 71 (For Mild A05 113076-9 1 12V Charger DC9012 For 9.6V 1.3Ah Metal) (5 pcs/pkg) Batteries (With Item 100) 792541-7 1 Recipro Saw Blade 78(For Wood) DC1422 1 12V Charger For 7.2V ~ 14.04V Ni-Cad & (5 pcs/pkg) Ni-Mh 1.3Ah ~ 3.0Ah Batter

ملخص المحتوى في الصفحة رقم 3

Item Description Type 1 Type 2 Type 3 Type 4 No. Motor D.C. 9V 1 629544-7 (No 629578-0 (No 629581-1 (With Item 16) Longer Available) Longer Available) Housing Set 15 410995-3 (No 414344-6 (No 182406-5 (Set) Longer Available) Longer Available) (Old 414975-1) Housing Set 25 410996-1 (No 414345-4 (No 182406-5 (Set) Longer Available) Longer Available) (Old 414976-9) Gear Com. 3 153157-7 (No Longer Available) 153202-8 16 Spur Gear 221920-7 (No Longer Available) 221882-9 Shoe 24 343456-7 343875-7 7

ملخص المحتوى في الصفحة رقم 4

2. New method of installing Blades (For Type 4 Slider Com.) Tighten the bolt se curely while Loosen the blade se cur ing bolt fully Fit the pin on the slider in the hole in the mak ing sure that the blade will not with the hex wrench. Keep the back blade shank. be ex tracted even though you try to edge of the blade fit ting into the roller pull it out. and in sert the blade be tween the blade Note: clamp and the slider as far as it will go.l The hole in the blade shank will be aligned CAU TI