Moen 62700 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

MODELS 2600, 2700, 5401, 62600, 62700, 72615, 72700 and MODEL SERIES T471,
MT662C
T473, T555, T666, T777, T888, TL470, TL471, TL473, L2600, L2700
®
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
TUB AND SHOWER VALVES
Available with three or four port castings, with and without stops.
Connections are either 1/2 inch I.P.S. pipe or 1/2 inch copper sweat connections.
If the Moen Slip Fit spout is used, a 1/2 inch copper drop and lookout may be used.
Measurements
IMPORTANT

ملخص المحتوى في الصفحة رقم 2

‰ ‰ ‰ WITHOUT STOPS WITH STOPS Stop Operation Plaster Ground ‰ 7" DIA 7" DIA ‰ PROTECTIVE (178mm) (178mm) TO REMOVE STOP TUBE COVER: CAP CC - This type is integral with casting, actuated by screwdriver, and require a SHOWER SHOWER 90° turn to open or close. When the screwdriver slot is vertical, the rubber Place a flat bladed screwdriver into the slot at the base of the stop is closed, and when the slot is horizontal, the rubber stop is open. stop tube cover near a support tab as you did when

ملخص المحتوى في الصفحة رقم 3

‰ ‰ ‰ WITHOUT STOPS WITH STOPS Stop Operation Plaster Ground ‰ 7" DIA 7" DIA ‰ PROTECTIVE (178mm) (178mm) TO REMOVE STOP TUBE COVER: CAP CC - This type is integral with casting, actuated by screwdriver, and require a SHOWER SHOWER 90° turn to open or close. When the screwdriver slot is vertical, the rubber Place a flat bladed screwdriver into the slot at the base of the stop is closed, and when the slot is horizontal, the rubber stop is open. stop tube cover near a support tab as you did when

ملخص المحتوى في الصفحة رقم 4

MODELS 2600, 2700, 5401, 62600, 62700, 72615, 72700 and MODEL SERIES T471, MT662C T473, T555, T666, T777, T888, TL470, TL471, TL473, L2600, L2700 ® INSTALLATION INSTRUCTIONS THESE INSTRUCTIONS MUST BE LEFT WITH HOMEOWNER TUB AND SHOWER VALVES Available with three or four port castings, with and without stops. Connections are either 1/2 inch I.P.S. pipe or 1/2 inch copper sweat connections. If the Moen Slip Fit spout is used, a 1/2 inch copper drop and lookout may be used. Measurements IMPORTANT