Saris The T-Rax Sport 4 bike دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

THE T-RAX SPORT
INSTALLATION MANUAL
Please READ and FOLLOW all instructions carefully.
Tongue Weight Limitations
Hitch Type Tongue Weight Maximum Load
FINALLY – A
COMPANY THAT
1-1/4” 200 lbs. 2 bikes/70 lbs.
LOVES BIKES AS
200 lbs. 3 bikes/105 lbs.
MUCH AS YOU DO.
300 lbs. 4 bikes/140 lbs.
Chances are, your bikes are just
300 lbs. 2 bikes/70 lbs.
like ours - your most valued 2”
possessions. And if it has the
300 lbs. 3 bikes/105 lbs.
Saris name on it, nothing we
T-Rax Sport 2 bike (502)
build

ملخص المحتوى في الصفحة رقم 2

MOUNT CARRIER TO VEHICLE CONTINUED: 2 3 4 Insert rack into the receiver base Insert pin into Secure with clip. and insert long bolt into receiver bottom hole as and rack as shown. shown. (Note: Pin can be removed when rack is empty to fold rack down. Do not drive with rack in down position) 6 7 5 Place lanyard ring around Attach nut loosely-do not Attach 1/2”washer. sleeve. Insert fully tighten until all nuts final bolt into and bolts are loosely receiver base, placed. through sleeve and out t

ملخص المحتوى في الصفحة رقم 3

ADJUST ARMS ON CARRIER: 12 10 11 Unhook clasp and pull pin from the rack. To secure arm, be sure that the Rotate arm up and out away clasp is closed. from vehicle. Align holes and insert pin. MOUNT BIKES TO CARRIER: 13 14 Place bikes on carrier arms, alternat- ing direction of handle-bars. The pur- chase of Saris Protect-O-Pads(#2060) is recommended to protect contact areas. Make sure foam pads are free of debris as it could scratch vehicle's finish. Cover inner pedal of first bike Press yello

ملخص المحتوى في الصفحة رقم 4

CHECK CARRIER STRAPS & STABILITY  Shown below are the different possible positions for mounting mens, womens, and non-traditional style frames.  Check Clearance. Bike must rest high enough to allow bike tires 12” minimum of ground clearance. It’s recommended to load smallest and lightest bikes last.  Heaviest bikes should be placed closest to the vehicle (35lbs. per bike maximum)  To use tilt and release features, remove cotter and clevis pins and tilt carrier away from vehicle. Note: D