Scotts CD36C دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Prizelawn® CD36C
COMMERCIAL DROP SPREADER
MODEL CD36C
OWNER’S MANUAL

ملخص المحتوى في الصفحة رقم 2

Assembly Instructions 3/16 X 2” Cotter Pin Handle Brace Leg Nut 1/4-20 X 1/2” Lock Hex Bolt Washer Drive Wheel 1. Remove spreader and components from carton. 2. Slide Wheels onto each end of Axle with Place Hopper on it’s front panel, insert two (2) 1/4-20 the longer portion of the Wheel facing the X 1/2” Hex Head Bolts through the Leg, flattened Hopper. Secure Wheels with 3/16 dia. x 2” end of Handle Brace, and holes in Hopper as shown. Cotter Pins. Install Lockwashers and Nut

ملخص المحتوى في الصفحة رقم 3

Operation 1. Before filling Hopper, make sure spreader 4. Operate spreader at 3 MPH pace. Handle Lever is in the “OFF” position. Always fill (33.3 feet in 7.5 seconds) spreader on walk or drive, not on the lawn. 5. Apply two header strips at each end 2. Loosen Rate Control Knobs and move the Tie of area to treated and then proceed Bar to setting recommended for the product lengthwise between the header strips. applied. If PrizeLAWN settings are not available, Be sure

ملخص المحتوى في الصفحة رقم 4

Parts List for Model CD36C 19 24 20 15 24 18 21 17 14 16 13 12 1 22 2 11 3RH 4 6 7 9 5 23 3LH 10 8 ITEM PART # DESCRIPTION PART OF OUR SERVICE IS PROVIDING 1 14211-1 HOPPER ASSEMBLY REPLACEMENT PARTS. Parts may be 2 14414-2 SHUTOFF BAR ASSEMBLY* obtained through your local distributor. 3 RH. 14643-1 AGITATOR/AXLE ASSEMBLY-LH. * Be sure to give: 3 LH. 14644-1 AGITATOR/AXLE ASSEMBLY-RH.* 4 14231 BEARING SUPPORT ASSEMBLY* 1. SPREADER MODEL NUMBER 5 14235 AGITATO