System Sensor 2100D دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION AND MAINTENANCE INSTRUCTIONS
2100D and 2100TD Photoelectronic
A Division of Pittway
3825 Ohio Avenue, St. Charles, Illinois 60174
Smoke Detectors
1-800-SENSOR2, FAX: 630-377-6495
Specifications
Diameter: 5.5 inches (140 mm)
Height (including mounting bracket): 1.7 inches (43 mm)
Weight: 5.3 oz. (150 g)
Operating Temperature Range: Model 2100D: 32° to 120°F (0° to 50°C)

ملخص المحتوى في الصفحة رقم 2

Figure 1. Surface mounting of 2100D smoke detector The screw terminal block will accept 14 – 22 gauge wire. 1 on 3 / -inch and 4-inch octagonal box: For best system performance, all wiring should be installed 2 in separate grounded conduit; do not mix fire system wiring in the same conduit as any other electrical wiring. Twisted pair may be used to provide additional protection against extraneous electrical interference. 1 Wire connections are made by stripping about / inch of 4 insulation

ملخص المحتوى في الصفحة رقم 3

LED LED Figure 3. Wiring diagram for the 2100D and 2100TD detector: + EOL RESISTOR INITIATING SPECIFIED BY PANEL LOOP MANUFACTURER – + + + + + + + UL LISTED + COMPATIBLE – – CONTROL PANEL RA400Z RA400Z REMOTE REMOTE ANNUNCIATOR ANNUNCIATOR OPTIONAL CLASS A WIRING A78-2331-02 or analog voltmeter to check the detector sensitivity as CAUTION described in the test module’s manual. Dust covers are an effective way to limit the entry of dust C. Smoke Entry Test into smoke detector sensing chambers.

ملخص المحتوى في الصفحة رقم 4

NOTE: (Model 2100TD only) Before removing the de- Gently press the housing until it locks in place. Check tector cover, note the position of the thermistors. to make sure that the thermistors are in the upright po- Make sure the thermistors are not bent over when sition (2100TD). the housing is replaced. 9. Reinstall the detector. 1. Remove detector housing by gently prying the four hous- 10. Notify the proper authorities the system is back in op- ing tabs on the bottom of the base with a sma