ملخص المحتوى في الصفحة رقم 1
MODEL 3304, 3304L
MODEL 3895, 3895L
SECURITY INSTRUMENTS, INC.
SMOKE & FIRE ALARM WITH SILENCE FEATURE
AND ALARM ORIGINATION FEATURE
READ ALL INSTRUCTIONS
Table of Contents:
Page #
Smoke Alarm Limitations and Functions ................................. 2
Recommended Location of Alarms ......................................... 3
Avoid These Locations ........................................................... 4
Early Warning ........................................................................
ملخص المحتوى في الصفحة رقم 2
SMOKE ALARM LIMITATIONS AND FUNCTIONS ® There are three basic smoke alarm types: IoPhic , Ionization and Photoelectric. ® IoPhic is an ionization alarm containing a patent-pending Universal Smoke Sensing Technology. ® IoPhic alarms are very effective at detecting fast flaming fires and also respond very quickly to slow smoldering fires - up to 87% faster than the maximum allowable alarm limit (UL217 Smoldering Smoke Test on 5/26/2010, Underwriters Laboratories Project #09CA38078). Ioniza
ملخص المحتوى في الصفحة رقم 3
RECOMMENDED LOCATION OF ALARMS • Locate the first smoke alarm in the immediate area of the bedrooms. Try to protect the escape route as the bedrooms are usually farthest from an exit. If more than one sleeping area exists, locate additional smoke alarms in each sleeping area. If a hall is more than 40 feet (12 meters) long, install a smoke alarm at each end. • Locate additional smoke alarms to protect any stairway as stairways act like chimneys for smoke and heat. • Locate at least one smoke ala
ملخص المحتوى في الصفحة رقم 4
AVOID THESE LOCATIONS • the garage – products of combustion are produced when you start your vehicle. • near appliances or areas where normal combustion regularly occurs (kitchens, near furnaces, gas hot water heaters). Use smoke alarms with photoelectric sensors or smoke alarms with Silence Feature for these areas. • in areas with high humidity, like bathrooms or areas near dishwashers or washing machines. Install at least 3 feet (0.9 meters) away from these areas. • in areas of turbulent air
ملخص المحتوى في الصفحة رقم 5
ALARM/BRACKET BATTERY LOCKING 2. Insert the pin into the hole for the feature you are activating. Refer to the diagram below for correct placement. INSERT ALARM INSERT BATTERY LOCKING PIN HERE LOCKING PIN HERE TO DEACTIVATE THE LOCKING FEATURES: To remove the smoke alarm for cleaning or servicing or to replace the battery, you must first remove the appropriate locking pin, if it has been installed. 1. Turn off AC power to the circuit. 2. Use long nose pliers to pull the locking pin out of the ho
ملخص المحتوى في الصفحة رقم 6
The yellow wire is used only for multiple station operation with USI ELECTRIC or UNIVERSAL Model alarms only. Connecting this yellow wire to any other circuits may result in damage and smoke alarm malfunction. When alarms are interconnected, all smoke alarms must be powered from a single AC branch circuit. If local codes do not permit, be sure the neutral wire is common to both phases. The maximum wire run distance between the first and last alarm/device in an interconnected system is 1,000 feet
ملخص المحتوى في الصفحة رقم 7
b. Interconnected alarms will sound and then stop. c. The originating smoke alarm will continue to sound 60 seconds to allow ample time to quickly find originating alarm. ® Alarm Origination condition, press and hold the Test button RESET: To reset the QUICK FIND on any alarm for at least 10 seconds and then release. Reset after each alarm. The reset feature will reset all interconnected units. TROUBLE/SERVICE ALARM: If the smoke alarm chirps 3 times every 40 seconds after the red LED flashes a
ملخص المحتوى في الصفحة رقم 8
OPTIONAL BATTERY DRAWER TAMPER LOCKING PIN: To make your battery drawer tamper resistant, a locking pin has been provided (breakaway part on mounting bracket). NOTE: If this feature has been activated, you will need to deactivate it by removing the battery drawer tamper pin located at side of battery drawer. Refer to Page 5. (R) Pull the QUICK DRAW battery drawer open and remove the battery. While observing polarity, push the replacement battery into the battery drawer until it is held securely
ملخص المحتوى في الصفحة رقم 9
OPERATIONAL SUMMARY CONDITION OF ALARM AUDIBLE & VISUAL SIGNALS BEFORE SOLUTION / RECOMMENDATION HORN RED LED GREEN LED SOLUTION / RECOMMENDATION Silent Blinks On once Stays On AC Power is present. DC Power is present. approx every 40-45 seconds Silent Blinks On once Off AC Power is not present and alarm is receiving DC approx every Power. Check the breaker or fuse box for power. If the breaker or fuse box looks normal, call a licensed 40-45 seconds electrician for assistance. Press and hold the
ملخص المحتوى في الصفحة رقم 10
FIVE YEAR LIMITED WARRANTY MODELS 3304, 3304L MODELS 3895, 3895L USI ELECTRIC, INC./UNIVERSAL SECURITY INSTRUMENTS, INC. ("USI") warrants your USI product to be free from defects in material and workmanship for a period of five (5) years from the date of purchase. This warranty shall not apply to any batteries used in the product or to any damage which may be caused by such batteries. This warranty applies only to the original consumer purchaser and only to products used in normal residential us
