Dell CP دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

'HOOŒ/DWLWXGHŒ&3DQG&3L
3URFHVVRU0RGXOHDQG7KHUPDO
&RROLQJ$VVHPEO\,QVWDOODWLRQ
This document updates the information found in your Dell Latitude CP and CPi
Service Manual. It describes how to install a microprocessor module and thermal
cooling assembly (TCA) in a Dell Latitude CP or CPi portable computer.
3URFHVVRU0RGXOH
To install the processor module in the system board, perform the following steps:
1. Carefully position the processor module and press down evenly at all four corne

ملخص المحتوى في الصفحة رقم 2

2. Install the three screws to secure the processor module to the system board. 3. Place a new processor hold-down clip (either a one-slot or two-slot clip) over the corner of the fence, as shown in Figure 1, and press the clip down to lock it in place. Always use a new clip. Do not reuse an old clip. 7KHUPDO&RROLQJ$VVHPEO\ Before you install the TCA in the computer, you must attach Kapton tape to the left tab at the front of the TCA (see Figure 2). The tape must be attached so that the e

ملخص المحتوى في الصفحة رقم 3

TCA (top) tab tape 1/16 inch (.16 cm) )LJXUH7DE&URVV6HFWLRQ &$87,217KHWDSHPXVWQRWJRRYHUWKHWRSRIRUFRPHLQFRQWDFWZLWKWKH WKHUPDOWUDQVIHUSDGRQWKHWRSRIWKH7&$,IWKHWDSHWRXFKHVWKHWKHUPDO WUDQVIHUSDGLWZLOOGHJUDGHWKHSDVVLYHFRROLQJVROXWLRQDQGFRXOG GHJUDGHWKHV\VWHPSHUIRUPDQFH 2. Wrap the tape under the bottom edge and then up the front of the tab, as shown by the arrow in Figure 2. Wrap the tape over the top edge of the tab and onto the top of the