Apple 073-0542 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

K Power Mac G4 Cube
Battery
Replacement Instructions
Be sure to follow these instructions carefully. Failure to follow these
instructions could result in damage to your equipment and may void your
warranty.
Replacing the battery requires five basic steps:
• Turn off the computer.
• Remove the computer core from the enclosure.
• Remove the installed battery.
• Install the replacement battery.
• Replace the computer core in the enclosure.
Note: A video version of the replacement in

ملخص المحتوى في الصفحة رقم 2

Removing the Computer Core From the Enclosure Warning: Always turn off your computer before opening it to avoid damaging its internal components. 1 Place your computer on a clean, flat surface. 2 Shut down your computer by opening the Special menu and choosing Shut Down. Then wait five minutes for the computer’s internal components to cool down. 3 Unplug all cables from the computer except the power cord. Note: If you have never plugged in your computer, connect the computer’s power

ملخص المحتوى في الصفحة رقم 3

7 Push down on the latch to release it. Extended Latch Latch Allow the latch to extend completely. 8 Gently pull the core from the computer enclosure and place it on a soft cloth. Core Enclosure Power Mac G4 Cube Battery - 3

ملخص المحتوى في الصفحة رقم 4

Battery Replacing the Battery 1 Note the orientation of the installed battery’s positive (+) end. (Positive and negative signs are also marked on the battery holder.) 2 At the battery’s positive end, place your finger between the battery and the holder. Gently pry the battery out of the holder and out of the computer. Warning: Batteries contain chemicals, some of which may be harmful to the environment. Please dispose of used batteries according to your local environmental laws and

ملخص المحتوى في الصفحة رقم 5

Replacing the Computer Core in the Enclosure 1 Holding the core by the latch, insert the core into the computer. Note: The core fits into the enclosure only one way. Position the core so the ports are toward the back of the enclosure. Core Enclosure 2 With a flat hand, press down on the latch until it locks into place. Firmly press the core to ensure it is fully secured within the enclosure. Important: Do not lift or carry your computer by the core latch. The enclosure could fall of

ملخص المحتوى في الصفحة رقم 6

3. Turn your computer upright and reconnect all cables. 4. Restart your computer. Warning: Never turn on your computer unless all of its internal and external parts are in place and it is closed. Operating the computer when it is open or missing parts can damage your computer or cause injury. Resetting Date and Time Replacing the battery changes the date and time settings on your computer. Use the Date & Time control panel to correct the date and time. K Apple Computer, Inc. © 200