LaCie Box دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

box
DESIGN BY NEIL POULTON
Quick Install Guide

ملخص المحتوى في الصفحة رقم 2

ملخص المحتوى في الصفحة رقم 3

Box Content box, design by Neil Poulton External power supply USB cable CD Quick Install Guide NOTE: The LaCie box is uniquely produced to accommodate SATA 3.5” hard disk drives. No other drives save for SATA 3.5” hard disk drives are compatible with the LaCie box. Please note that, due to the numerous manufacturers of SATA 3.5” hard disk drives, LaCie cannot guarantee that every model will work with the LaCie box. Protect your investment – register at www.lacie.com/register to download LaCie

ملخص المحتوى في الصفحة رقم 4

Rear View OFF/ON power switch USB 2.0 port Power supply connection NOTE: The LaCie box is uniquely produced to accommodate SATA 3.5” hard disk drives. No other drives save for SATA 3.5” hard disk drives are compatible with the LaCie box. Please note that, due to the numerous manufacturers of SATA 3.5” hard disk drives, LaCie cannot guarantee that every model will work with the LaCie box. NOTE: If you are replacing a drive, take care to make certain that it has cooled before touching it. NOTE

ملخص المحتوى في الصفحة رقم 5

Setup Steps I) Install an internal hard disk drive. 1. Make certain the power and USB 2.0 cables are disconnected from the LaCie box. 2. Turn the box over so that the rubber feet are pointing up. Please note the two plastic bands for prying the bottom plate from the top shell. 3. Open the casing by taking one plastic band in each hand, between the thumb and index finger, and pull gently until the bottom plate and the top shell have come apart. 4. Turn the enclosure over, onto its rubber f

ملخص المحتوى في الصفحة رقم 6

7. Replace the casing by aligning the rear ports with their respective slots, and then gently press down on the front until you hear an audible “click”, indicating closure. NOTE: LaCie does not recommend removing the two bands on the face of the drive. In such an event, please take great care when separating the top shell from the bottom plate. Should the need arise, you may gently pull back the plastic face exactly where it joins to the bottom plate in the front; then, gently pry the

ملخص المحتوى في الصفحة رقم 7

ملخص المحتوى في الصفحة رقم 8

ملخص المحتوى في الصفحة رقم 9

ملخص المحتوى في الصفحة رقم 10

ملخص المحتوى في الصفحة رقم 11

ملخص المحتوى في الصفحة رقم 12

ملخص المحتوى في الصفحة رقم 13

ملخص المحتوى في الصفحة رقم 14

ملخص المحتوى في الصفحة رقم 15

ملخص المحتوى في الصفحة رقم 16

ملخص المحتوى في الصفحة رقم 17

ملخص المحتوى في الصفحة رقم 18

ملخص المحتوى في الصفحة رقم 19

ملخص المحتوى في الصفحة رقم 20