Seagate BARRACUDA ST340016A دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Computer
Motherboard
 Master or single drive: To configure the drive as a master or a single
drive, set the jumper on pins 7 and 8.
 Drive is slave: To configure the drive as a slave, or second drive on
®

Barracuda ATA IV Family Installation Guide
the cable, remove all the jumpers.
ST380021A, ST360021A, ST340016A, ST320011A
 Master with non ATA-compatible slave: Use this setting if the slave
Publication number: 100129216, Rev. A
drive is not recognized. Configure the master drive with a jum

ملخص المحتوى في الصفحة رقم 2

For more information, see the earlier section on the Ultra ATA/100 Preparing the Drive with Disk Manager or DiscWizard requirements. In addition, some legacy BIOS may cause a hang due Installing a Single Drive to the large drive capacity. Consider using the alternate capacity If you are installing a single drive, we recommend using Disk Manager jumper if it is available on your drive model. to automatically partition and format your drive. Disk Manager software Use the alternate capacity jumper