Seagate CHEETAH 18XL ST318404LW/LC دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

 Some systems provide a cable designed to connect to the J5 jumper block
on the drive to remotely set the ID. You can connect this cable to J5 and
use the host-provided remote switch to set the SCSI ID.
Cheetah 18XL Installation Guide

Model ST318404LW/LC and ST39204LW/LC SCSI interface disc drive
Publication Number: 75789507, Rev. B, August 2000
Handling precautions/Electrostatic discharge protection
• Disc drives are fragile. Do not drop or jar the drive and handle the drive
only by the ed

ملخص المحتوى في الصفحة رقم 2

7. Format the drive J2 Drive with Pin 1 The drive has been formatted at the factory. You do not need to per- low level HDA up, PCB down, viewed form another low level format on this drive unless you decide to perform cer- from front Pin 1 Reserved Positions HDA tain diagnostics through the host adapter. If you do decide to perform a low Delay Motor Start option (valid level format, do not abort the format as this is likely to make the drive inoper- only if the Enable Motor Start J6 jumper