Seagate CHEETAH ST3146854LW/LC دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation instructions
1. Set the SCSI ID
Determine which SCSI IDs are already being used in the system and then
assign this disc drive a SCSI ID that isn’t already being used. Use the J6
connector located on the front of the drive to set the SCSI ID (see Figure 1).
Cheetah 15K.4 Installation Guide
®
 Most Cheetah 15K.4 drives are factory set with the SCSI ID set at 0. If
ST3146854LW/LC, ST373454LW/LC and ST336754LW/LC
this is the only SCSI drive in your system and there are no other SCSI
S

ملخص المحتوى في الصفحة رقم 2

minutes for ST336754 models, 60 minutes for ST373454 models, and 90 J2 Pin 1 minutes for ST3146854 models. Reserved Positions Protect against power failure or other power interruptions during the format. Delay Motor Start option (valid a. Turn on DC power to the host system. Drive with only if the Enable Motor Start HDA up, PCB jumper is not connected) b. Boot the system from a system floppy, CD, or from a previously down, viewed (default) from front Pin 1 Disable the Delay Motor Start optio