AltiGen comm TRITON T1 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

TRITON T1 BOARD
QUICK INSTALLATION GUIDE
MVIP BUS MVIP Connector System
Termination Switch Configuration Switch
TRITON T1 BOARD
The Triton T1 Board uses the following signaling and framing features:
Signaling: loop start, ground start, E&M immediate start, E&M wink start*
Line Encoding: AMI, B8ZS*
*recommended
MINIMUM SYSTEM REQUIREMENTS:
• IBM/PC AT compatible system with adequate number of full-size ISA and PCI slots
• 233 Mhz Pentium processor (or better)
• 2 - 4 GB Hard Disk Drive Space (de

ملخص المحتوى في الصفحة رقم 2

STEP 1: MAKE SURE BOARD ID OF QUANTUM BOARD(S) IS SET PROPERLY The first (outer-most) Quantum board ID should be set as 0, the next board ID as 1, and so forth. Do not skip slots between boards. Refer to the Quantum Quick Installation Guide for proper installation instructions. CPU STEP 2: INSERT TRITON T1 BOARD(S) INTO PCI SLOTS After installing the Triton T1 Board(s), make sure the Triton T1 board ID is set properly. The first (outer-most) Triton T1 Board should be set at 0, the next board ID

ملخص المحتوى في الصفحة رقم 3

STEP 3: CONNECT THE MVIP CABLE AND TERMINATE THE MVIP BUS IMPORTANT! Make sure the MVIP bus is terminated (set to close) at the Quantum Board with ID of 0. All other boards are not terminated (MVIP Bus Termination Switch set to OPEN). DO NOT TWIST THE MVIP CABLE. It should lay flat when connected to boards, as shown below. The MVIP Bus is only terminated on one board per system. CPU Board Triton Quantum MVIP Bus Termination Switch CLOSE 0 1 CPU 3 2 1 0 STEP 4

ملخص المحتوى في الصفحة رقم 4

STEP 6: TURN SYSTEM ON AND INSTALL ALTIWARE OE OR START ALTIWARE OE TO CONFIGURE NEW T1 TRUNKS Please see the following sections in the AltiWare OE manuals for details on how to configure T1 trunks: • System Administration Manual Chapter 3, Board Configuration Chapter 4, Trunk Configuration TECHNICAL SUPPORT • End users, please contact your Authorized AltiGen Dealer. • Authorized AltiGen Dealers, Call AltiGen Technical Support at 1-888-ALTIGEN (258-4436) Send E-mail to: support@altigen.com • Ple