Apple ATA Drive Cable دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Power Mac G4 / Macintosh Server G4
ATA Drive Cable
Replacement Instructions
Be sure to follow the instructions in this sheet carefully. Failure to follow these instructions
could result in damage to your equipment and may void your warranty.
Note: Written and video instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Tools Required
No tools are required for this procedure.
Opening the Computer
Warning: Always turn off you

ملخص المحتوى في الصفحة رقم 2

8. Lift the latch on the right side access panel. (Figure 1B) 9. Gently lower the access panel until it lies flat. To avoid scratching the case, lower the panel onto a soft, clean cloth. (Figure 2) Warning: If you see any lights glowing on the main logic board, the computer has not been shut down. Close the side access panel and shut down the computer before proceeding. Removing the Installed Cable 1. Disconnect the ATA cable from the logic board. (Figure 3A) 2 Disconnec

ملخص المحتوى في الصفحة رقم 3

Apple Computer, Inc. © 2001 Apple Computer, Inc. All rights reserved. Under the copyright laws, this document may not be copied, in whole or in part, without the written consent of Apple. The Apple logo is a trademark of Apple Computer, Inc., registered in the U.S. and other countries. Use of the “keyboard” Apple logo (Option-Shift-K) for commercial purposes without the prior written consent of Apple may constitute trademark infringement and unfair competition in violation of feder

ملخص المحتوى في الصفحة رقم 4

2 3 B A Power Mac G4 ATA Drive Cable - 4