Contec 4(FIT)GY 1 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Ver.1.00

F&eIT Series
Isolated Digital I/O Module



DIO-4/4(FIT)GY


This product is an expansion module (device module) that adds
digital signal I/O interfaces to one of various types of controllers.
The product is used in combination with the I/O controller
module (*1) or microcontroller unit
(*1) in the F&eIT Series.
This product can perform a maximum of 4 points of
Optocoupler isolated input and 4 points of Optocoupler isolated
out

ملخص المحتوى في الصفحة رقم 2

0 0 Ver.1.00 CAUTION Functions and control method by When connecting one of the modules to a controller module, controller connected the internal current consumption should be taken into This product can be connected to a variety of controllers. account. If the total current exceeds the capacity of the power supply unit, the integrity of the operation cannot be Supported controllers guaranteed. For further details, please see the Controller Microcontroller Unit : CPU-SBxx(FI

ملخص المحتوى في الصفحة رقم 3

1 0 0 7 Ver.1.00 Example of a Connection to Current Sink Output Interface Connector Module External circuit Vcc How to Connect an Interface Connector When connecting the Module to an external device, you can 3k Ω use the supplied connector plug. Minus External common To wire the Module, strip the sheath about 9 - 10mm from an power supply 12V - 24VDC end of the wire and insert the exposed wire into an opening. Input Current sink Optocoupler pin Tighten the screw to fasten the

ملخص المحتوى في الصفحة رقم 4

1 0 0 7 Ver.1.00 Using Outputs Y0 + External power supply Load 12V - 48VDC Output plus common - Output pin (e.g., connector Y1) Output minus common Example of Connecting Outputs and Inputs External power supply 12V - 24VDC - + Output module Intput module Common plus for intput Common plus for output Output Intput Common minus for output Setting a Device ID The controller module distinguishes and keeps track of the modules that are connected to it by assigning device IDs to