Renesas M3T-DUMMY64 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

M3T-DUMMY64
Dummy IC for 64-pin 0.8-mm-pitch QFP
User's Manual
Keep safety first in your circuit designs!
• Renesas Technology Corporation and Renesas Solutions Corporation put the maximum effort into making semiconductor products better and more
reliable, but there is always the possibility that trouble may occur with them. Trouble with semiconductors may lead to personal injury, fire or property
damage. Remember to give due consideration to safety when making your circuit designs, with appropr

ملخص المحتوى في الصفحة رقم 2

1. Outline The M3T-DUMMY64 is an accessory tool product which (1) M3T-DUMMY64 main unit connects the probe of an emulation pod and a target system. Its dimensions are the same as those of 64-pin 0.8-mm-pitch QFP (14 x 14 mm) IC packages (64P6N-A). 2. Package Components (see Figure 1) (2) Socket main unit (3) Socket frame (1) M3T-DUMMY64 main unit .................................. x1 (2) Socket main unit .................................................... x1 (3) Socket frame (for 64P6N-A)......

ملخص المحتوى في الصفحة رقم 3

6. External Dimensions of the M3T-DUMMY64 Symbol Dimension [mm] A 5.0 b 0.3 D 14.0 E 14.0 0.8 e HD 18.0 HE 18.0 M 6.3 Upper connector J1: AXN640545P (made by Matsushita Electric Works, Ltd.) Upper connector J2: AXN540045P (made by Matsushita Electric Works, Ltd.) Material: Glass epoxy board Board Pin Material: Bronze phosphide Plating: Solder plating 1 : Pin number of the M3T-DUMMY64 Material: Heat tolerant resin (body) Upper connectors 1 : Pin number of the upper connectors (J1, J2) Copper allo

ملخص المحتوى في الصفحة رقم 4

8. Precautions CAUTION Cautions to Be Taken for This Product: •Do not solder the M3T-DUMMY64 main unit directly on a target board. Be sure to use the included socket. • Before mounting the M3T-DUMMY64, be sure to check the pin positions. • Holder patterns are required at each of the four corners of the target foot pattern. (see Figure 4). • Be sure to solder the holders of the socket. An insufficient amount of solder applied to the holders may cause a poor contact, so be careful. • For soldering