Renesas RSKH8S2215R دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

1. Installation
Do not connect the E8 debugger hardware until the software support has been installed.
1. Insert the CD into your computer’s CD-ROM drive. The CD should automatically run the installation program. If the installer does not start, browse to the RSK
directory from the CD root folder and double click on ‘setup.exe’.
2. Choose the desired setup language and click OK.
3. You will be presented with Welcome screen, Click .
4. The software licence agreement will be d

ملخص المحتوى في الصفحة رقم 2

2. Connection 13. Connect the E8 to the ‘E8’ connector on the RSK using the ribbon cable. 14. Plug in the LCD module to ‘LCD’ connector on the RSK ensuring that the pin 1 designation corresponds to the marking on the RSK. 15. Connect the E8 debugger to a spare USB port on your PC. The ‘Found New Hardware’ Wizard will appear. Please follow the steps below to install the drivers. Note that administrator privileges are required for a Windows™ 2000/XP machine. 16. For Windows XP Select the ‘No

ملخص المحتوى في الصفحة رقم 3

First time E8 Direct Driver install only The ‘Found New Hardware’ Wizard will appear. 41. Select the ‘No, not this time’ option and click . 42. Verify the “Recommended” option is selected and click . 43. If using Windows XP, skip to step 45; otherwise click . 44. Click to install the driver. 45. Click to close the wizard. You may be prompted to select the USB device in a new dialog: 46. Click to select the ‘E8DIRECT’ USB device. 47. In

ملخص المحتوى في الصفحة رقم 4

64. In the HMON Configuration dialog select ‘Compare with cache’ and Click . 65. The code will be downloaded to the device. 66. Click the ‘Reset – Go’ button. 67. The code will run and you will see the LEDs flash on the board. 68. Click the ‘Stop’ button. The code will stop and the source code opened at the current program counter. 5. Next Step After you have completed this quick start procedure, please review the tutorial code and sample code that came with the kit. Yo