SeaLand TankWatch Level Monitor System دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

DO-IT-YOURSELF
INSTALLATION INSTRUCTIONS
LEVEL MONITOR SYSTEM
Your TankWatch Level Monitor System contains these items:
The TankWatch Level Monitor System is
designed to operate on 12 VDC in a sewage
holding tank, and to signal a nearly full tank
condition. This instrument will give years of
reliable service if installed properly.
HOW IT WORKS...
SWITCH ASSEMBLY
INDICATOR
ASSEMBLY
Plenty of capacity... Red light glows...
2-No. 4x1/2”
all is well. nearly full.
MOUNTING SCREWS
4-No. 8x3/4”
GAS

ملخص المحتوى في الصفحة رقم 2

Following the wiring diagram, route wires on a 12VDC circuit using good electrical practice. 5 A. Connect the red wire through a 1/2-amp fuse (not supplied), to the positive DC source. B. Connect the white wire from the red LED to one of the white wires on the Float Switch Assembly. C. Connect the remaining white wire from the Float Switch Assembly to the negative DC source. Place the Switch Assembly into the tank with the Mount the Indicator Assembly. Fasten with the two gasket in place. Drive