ملخص المحتوى في الصفحة رقم 1
Please read this manual carefully before oper-
ating your set.
Retain it for future reference.
Record model number and serial number of
the set.
See the label attached on the back of the set
and quote this information to your dealer when
MW-71PY10
you require service.
MW-71PY10G
Model number :
OWNER’S MANUAL
Serial number :
P/NO : 3828VA0484E (RF04FA)
PLASMA MONITOR PLASMA MONITOR
ملخص المحتوى في الصفحة رقم 2
Safety Instructions Safety Instructions Safety Instructions Safety instructions have two kinds of information, and each meaning of it is as below. * The violation of this instruction may cause serious injuries and even death. WARNING The violation of this instruction may cause light injuries or damage of the NOTES product. Take care of danger that may happen under specific condition. W WARNING 1. Do not place the product in direct sunlight or near 8. Do not place heavy objects on the product. he
ملخص المحتوى في الصفحة رقم 3
ENGLISH Safety Instructions NOTE 1. Never touch the power plug with a wet hand. 8. Ensure the power cord doesn’t trail across any hot objects like a heater. This may cause an electric shock. This may cause a fire or an electric shock. 2. Disconnect from the mains and remove all con- nections before moving. 9. Do not plug when the power cord or the plug is damaged or the connecting part of the power out- 3. Do not place the product in a built-in installation let is loose. such as a bookcase or ra
ملخص المحتوى في الصفحة رقم 4
Safety Instructions Safety Instructions continued Safety Instructions continued CAUTION concerning the Power Cord : Most appliances recommend they be connected to a dedicated circuit; that is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner's manual to be certain. - This may cause a fire or an electric shock. Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, e
ملخص المحتوى في الصفحة رقم 5
ENGLISH Contents Contents Contents Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2~4 Special Menu Options Key Lock . . . . . . . . . . . . . . . . . . . . . . . . . . . . .23 Introduction ISM Method . . . . . . . . . . . . . . . . . . . . . . . . . . .23 Controls and Connection Options . . . . . . . . . .7~8 Low power . . . . . . . . . . . . . . . . . . . . . . . . . . . .23 Remote Control Key Functions . . . . . . . . . . . . . .9 XD Demo . . . . . . . . . . . . .
ملخص المحتوى في الصفحة رقم 6
Introduction Introduction Introduction What is a Plasma Display Panel (PDP)? If voltage is applied to gas within glass panels, ultraviolet rays are produced and fused with a fluorescent substance. At that instant, light is emitted. A Plasma Display is a next generation flat Display using this phenomenon. 160° - Wide angle range of vision Your flat panel plasma screen offers an exceptionally broad viewing angle -- over 160 degrees. This means that the display is clear and visible to viewers anyw
ملخص المحتوى في الصفحة رقم 7
ENGLISH Introduction Controls Controls Front Panel Controls Front Panel Controls TruSurround XT INDEX Switches LED Display on or off. MENU VOL INPUT Remote Sub power Button Control E, D Buttons Sensor VOLUME (F,G) Buttons Power Indicator MENU Button Illuminates red in standby INPUT Button mode, Illuminates green when the monitor is turned on. Owner’s Manual 7
ملخص المحتوى في الصفحة رقم 8
Introduction Connection Options Connection Options Back Connection Panel Back Connection Panel Remote Control Port S-Video Input EXTERNAL SPEAKER Connect your wired Connect S-Video out from (8 ohm output) remote control here. an S-VIDEO device to the Connect to optional S-VIDEO input. external speaker(s). DVI Input/Audio Input/RGB Input * For further information, EURO SCART SOCKET Connect the monitor output connector refer to ‘Speaker & Connect the euro scart of from a PC to the appropriate inpu
ملخص المحتوى في الصفحة رقم 9
ENGLISH DW POWER DASP Introduction Remote Control Key Functions Remote Control Key Functions - When using the remote control, aim it at the remote control sensor on the monitor. - Under certain conditions such as if the remote IR signal is interrupted, the remote control may not function. Press the key again as necessary. MODE Selects the remote operating mode: MNT, VCR, DVD, CABLE, HDSTB or AUDIO. LIGHT Select other operating modes, for the Illuminates the remote control buttons. remote to ope
ملخص المحتوى في الصفحة رقم 10
DW POWER ASP D Installation Installation Installation Ensure that the following accessories are included with your plasma display. If an accessory is missing, please contact the dealer where you purchased the product. 1.5V Batteries Owner’s Manual Power Cord MODE PIP MUTE SLEEP VOL CH WIN. POSITION SPLIT ZOOM WIN. SIZE ENTER MENU EXIT PIP INPUT ARC PLAY PAUSE STOP RECORD REW FF SKIP VIDEO COM1 COM2 RGB DVI HDMI KEY LOCK INDEX D-sub 15 pin cable DVI computer cable Remote Control Soft cloth (MW-71
ملخص المحتوى في الصفحة رقم 11
ENGLISH Installation Installation Instructions Installation Instructions • Install this monitor only in a location where adequate ventilation is available. GROUNDING Power Supply Ensure that you connect the grounding / earth wire to prevent possible electric shock. If grounding methods are not possible, have a qualified electrician install a separate circuit breaker. Do not try to ground the Short-circuit unit by connecting it to telephone wires, lightening rods, or gas pipes. Breaker W Wall Mou
ملخص المحتوى في الصفحة رقم 12
Installation External Equipment Connections External Equipment Connections NOTE: Not all cables shown are included with the plasma display. VCR Setup VCR Setup - To avoid picture noise (interference), leave an adequate distance between the VCR and Monitor. - Use the ISM Method feature to avoid having a fixed image remain on the screen for a long period of time. Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed image may remain visible on the screen. How t
ملخص المحتوى في الصفحة رقم 13
ENGLISH Installation External Equipment Connections External Equipment Connections Cable Cable TV Setup TV Setup - After subscribing to a cable monitor service from a local provider and installing a converter, you can watch cable TV program- ming. The monitor cannot display monitor programming unless a TV tuner device or cable TV converter box is connected to the Monitor. - For further information regarding cable monitor service, contact your local cable TV service provider(s). How to connect 1.
ملخص المحتوى في الصفحة رقم 14
Installation DVD Setup DVD Setup How to connect 1. Connect the DVD video outputs to the COM- PONENT (Y, PB, PR) or HDMI INPUT jacks and connect the DVD audio outputs to the AUDIO INPUT jacks on the monitor, as shown in the figure. 2. If your DVD only has an S-Video output jack, COMPONENT VIDEO INPUT 2 INPUT 2 COMPONENT PUT VIDEO VID RGB INPUT connect this to the S-VIDEO input on the mon- HDMI DVI INPUT AUDIO INPUT INPUT 1 INPUT 1 VICE) RL RL MONO S-VIDEO VIDEO AUDIO AUDIO VIDEO itor and connect
ملخص المحتوى في الصفحة رقم 15
ENGLISH Installation External Equipment Connections External Equipment Connections PC Setup PC Setup - This monitor provides Plug and Play capability, meaning that the PC adjusts automatically to its settings. The monitor sends configuration information (EDID) to the PC using the Video Electronics Standard Association (VESA) Display Data Channel (DDC) protocol. - The monitor perceives 640x480, 60Hz as DTV 480p based on the PC graphic card. In this case, change the screen scanning rate for the g
ملخص المحتوى في الصفحة رقم 16
Installation Monitor Display Specifications (RGB-PC / DVI-PC Mode) Horizontal Vertical Resolution Frequency(KHz) Frequency(Hz) 31.469 70.08 720x400 37.927 85.03 31.469 59.94 35.000 66.66 37.861 72.80 640x480 37.500 75.00 43.269 85.00 35.156 56.25 37.879 60.31 800x600 46.875 75.00 53.674 85.06 49.725 74.55 832x624 31.500 60.00 35.000 70.00 848x480 37.500 75.00 31.500 60.00 35.000 70.00 852x480 37.500 75.00 48.363 60.00 56.476 70.06 1024x768 60.023 75.02 54.348 60.05 1152x864 63.995 70.01 67.500 7
ملخص المحتوى في الصفحة رقم 17
ENGLISH Installation HDMI HDMI TM - HDMI , the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC." - This monitor can receive the High-Definition Multimedia Interface(HDMI). - This monitor supports HDCP(High-bandwidth Digital Contents Protection) Protocol for 480p, 720p, 1080i modes. - When you Connect with HDMI Source Devices (DVD Player or Set Top Box) supporting Auto HDMI function, automatically, support Plug & Play and then set t
ملخص المحتوى في الصفحة رقم 18
Operation Operation Operation T Turning on the Monitor urning on the Monitor Turning on the Monitor just after installation 1. Connect power cord correctly. At this moment, the Monitor is switched to standby mode. 2. Press the INPUT or button on the Monitor or press the POWER, INPUT button on the remote control and then the Monitor will switch on. Menu Language Selection Menu Language Selection - The menus can be shown on the screen in the selected language. First select your language. 1. Press
ملخص المحتوى في الصفحة رقم 19
ENGLISH Operation Picture Menu Options Picture Menu Options - Readjust Picture menu settings for each following input source as preferred. APC (Auto Picture Control) APC (Auto Picture Control) - APC adjusts the Monitor for the best picture appearance. - When adjusting Picture menu options (contrast, brightness, color, sharpness, and tint) manually, APC automati- cally changes to Off. 1. Press the APC button repeatedly to select the picture appearance setup option as shown below. Daylight Optimum
ملخص المحتوى في الصفحة رقم 20
Operation Picture Menu Options continued Picture Menu Options continued Fleshtone (Video1-2-3-4, Component 1-2, RGB-DTV, DVI-DTV and HDMI-DTV Mode only) Fleshtone (Video1-2-3-4, Component 1-2, RGB-DTV, DVI-DTV and HDMI-DTV Mode only) - Use Fleshtone to select the desired skin color option. APC PICTURE 1. Press the MENU button and then use D / E button to select the PICTURE menu. ACC SOUND Fleshtone G 0 G Contrast 100 2. Press the button and then use D / E button to select Fleshtone. TIMER Bright
