ملخص المحتوى في الصفحة رقم 1
Installation instructions
Ceramic Cooktop
KM 451
UV
To prevent accidents
and machine damage,
read the Operating Manual
before installation or use. M.-Nr. 05 361 940
ملخص المحتوى في الصفحة رقم 2
2
ملخص المحتوى في الصفحة رقم 3
Contents IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Safety distance above the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Appliance dimensions and countertop cut-out . . . . . . . . . . . . . . . . . . . . . . . . . 6 KM 451. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Installation . . . . . . . . . . . . . . . . . . . . . . . . . .
ملخص المحتوى في الصفحة رقم 4
IMPORTANT SAFETY INSTRUCTIONS Note to the installer: Please leave this instruction book with the consumer for the local electrical inspector’s use. The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire. recommended The cabinetry and venting hood should be installed first, to prevent damage to the cooktop. The countertop must be bonded with heat resistant (212 °F/100 °C) 2 ” 50mm adhesive to p
ملخص المحتوى في الصفحة رقم 5
IMPORTANT SAFETY INSTRUCTIONS This equipment has not been Safety distance above the designed for maritime use or for appliance use in mobile installations such as aircraft or recreational vehicles. However, under certain circumstances it may be possible for installation in these applications. Please contact the nearest Miele Dealer or the Miele Technical Service Department with specific requirements. Because of the heat radiated downwards from this type of appliance we do not recommend installin
ملخص المحتوى في الصفحة رقم 6
4 " 16 (916mm) (58mm) 36 5 " 16 2 (8mm) " 16 1 16 " 36 10 (930mm) max. R4 Appliance dimensions and countertop cut-out KM 451 c b b 1 a Spring clips b There must be at least 3 / " (83 mm) 4 of usable depth to the right hand side of the cut out. ^ Make the countertop cut-out following ^ Seal the cut surfaces with a suitable the dimensions given in the sealant to avoid swelling caused by illustration. moisture. Be sure the materials used are heat resistant. ^ Remember to maintain a minimum distance
ملخص المحتوى في الصفحة رقم 7
(75mm) 3 ” Installation Installing the spring clips Granite countertops For granite countertops, the spring b clips,a, must be placed in position and secured with strong, double-sided adhesive tape. In addition coat the ^ Fix the supplied spring clips,a, at edges of the spring clips with silicone the marked positions as shown sealant. above, by laying them on the upper The screws are not needed for granite edge of the cut-out and then securing them with the 3.5 x 25 mm countertops. screws suppli
ملخص المحتوى في الصفحة رقم 8
Installation Installing the cooktop ^ Feed the power cord down through the cut-out and connect the appliance to the power supply. The cooktop must not be permanently sealed into the ^ Position the cooktop on the spring countertop when installed. The clips,a. sealing strip under the edge of the ^ Then with a hand on each side of the top part of the cooktop provides a cooktop press down on the edges sufficient seal for the countertop. evenly until it clicks into position. When doing so make sure t
ملخص المحتوى في الصفحة رقم 9
Electrical connection WARNING: Caution: THIS APPLIANCE MUST BE All electrical work should be GROUNDED performed by a qualified electrician The appliance is provided with 3 leads; in accordance with local and L1 (black), L2 (red) and GND (green). national codes. They must be connected to a Disconnect the appliance from the dedicated line through the use of an main power supply before servicing. approved junction box. To reduce the risk of electric shock, make sure that the appliance is For furthe
ملخص المحتوى في الصفحة رقم 10
10
ملخص المحتوى في الصفحة رقم 11
11
ملخص المحتوى في الصفحة رقم 12
Alterations rights reserved / 0705 M.-Nr. 05 361 940 / 02 en-US
