Resumen del contenido incluido en la página 1
2.4GHz CORDLESS CALLER ID
TELEPHONE WITH CALL WAITING
40 CHANNEL AUTOSCAN
730901-TP2-27F
OWNER'S MANUAL
INSTALLATION AND
OPERATING
INSTRUCTIONS
PLEASE READ THIS
MANUAL CAREFULLY
BEFORE USE.
KEEP FOR
YOUR REFERENCE.
L D C C F
A AM M M M N N S SE EC C R RP PT T
P PM M N NE EW W T TO OT TA AL L
CALLS B AT T MSG DIR
I I
Resumen del contenido incluido en la página 2
Special Features ongratulations on your selection of a quality CORTELCO product . With proper care and by following the setup and user instructions in this manual, C this unit will provide you with years of trouble free service . CORTELCO is committed to providing quality products that fit your needs. We would like to have any comments or suggestions you might have on this product .You may mail your comments to:
Resumen del contenido incluido en la página 3
Special Features Luminous LCD Screen - The LCD Screen emits light for 8 seconds every time you press any of the TELEPHONE KEYPAD buttons. HANDSET Ringer Volume Level - Select the ringer volume level (HI, LOW, OFF). HANDSET Volume Control Switch - Select the receiver volume level(HI.MID,LOW). HEADSET JACK - Your telephone can utilize a headset for hands-free communication BELT CLIP- Use the BELT CLIP to hang your HANDSET on your belt. CALLER ID SYSTEM Multi-Function Large LCD Screen - Sho
Resumen del contenido incluido en la página 4
HANDSET Controls Notes IMPORTANT 1. HANDSET ANTENNA In order to get maximum life from the HANDSET battery pack, be sure to charge the HANDSET for 12 hours before initial use. 2. NEW CALL/MESSAGE IMPORTANT WAITING LED Placing your BASE UNIT near appliances such INDICATOR 9.BATT LOW as televisions, refrigerators, radios, or microwave INDICATOR ovensmaycauseinterference. L D C C F CALLS B AT T MSG DIR 3. LARGE LCD SCREEN
Resumen del contenido incluido en la página 5
Technical Information HANDSET Controls 1. HANDSET ANTENNA Technical Information This cordless telephone uses radio frequencies to allow mobility. There are certain 2. NEW CALL/MSG(MESSAGE )WAITING LED Indicator: Blinks when recording a new difficulties in using radio frequencies with a cordless telephone. While these are normal, incoming call or when receiving a Message Waiting signal, if you have subscribed to a the following could alter operation of your system. Voice Mai
Resumen del contenido incluido en la página 6
Problem Solving BASE UNIT CONTROLS Problem Solving section For your assistance, we have listed below a few common problems. Phone does not work, check the following: 1. BASE UNIT is plugged into power source. 2. HANDSET is charged. 3. TONE/PULSE Select switch is in the right position. 3. TONE/PULSE 1. TELEPHONE LINE 2. POWER-IN 4.TELEPHONE LINE CORD is plugged in the TELEPHONE JACK. SELECT SWITCH CONNECTION JACK CONNECTION JACK pg.6,28 Range of phone limited, check the follow
Resumen del contenido incluido en la página 7
Changing the Battery Pack BASE UNIT CONTROLS 1. TELEPHONE LINE CONNECTION JACK Changing the BATTERY PACK 2. POWER-IN CONNECTION JACK The BATTERY PACK provides power for the HANDSET of your cordless telephone. 3. TONE/PULSE Select Switch To Replace the BATTERY PACK: 4. ANTENNA: Raise or reposition for the best reception. 1. Remove the HANDSET BATTERY COMPARTMENT COVER by sliding it down. 5. IN USE/CHARGE LED Indicator: (IN USE) Lights up to indicate that the HANDSET is in TALK mode or an
Resumen del contenido incluido en la página 8
Recharging the Battery Pack Contents Safety Instructions............................................................................................................3 Battery Type Use the following type and size of BATTERY PACK: Getting Started.................................................................................................................5 Cordless Telephone BATTERY PACK 3.6V, 600mAh Cordless Telephone Operation....................................................................
Resumen del contenido incluido en la página 9
Security Contents Saving in the Phone Book.............................................................................15 NOTES: 1. You can store a maximum of 16 characters on the letter icon. Preferred Calls............................................................................................... 15 2. You can store a maximum of 16 digits on the number icon. Blocked Calls...................................................................
Resumen del contenido incluido en la página 10
Caller ID System Operation Safety Instructions IMPORTANT SAFETY INSTRUCTIONS TELEPHONE KEYPAD Characters To reduce the risk of fire, electric shock and /or injury, always follow these The TELEPHONE KEYPAD button are used to enter characters when basic safety precautions when using your cordless telephone equipment. entering names. You can enter names in the UPPER CASE or LOWER CASE letters. 1. Read and understand all instructions. Press
Resumen del contenido incluido en la página 11
Caller ID System Operation Safety Instructions E. If the telephone has been dropped or the case has been damaged. G.VOICE MAIL F. If the telephone exhibits a distinct change in performance. This telephone enables you to store the Voice Mail Post Code number in your area. 16. Never install telephone wiring during a lighting storm. This will automatically connect you to the Voice Mail service provider with one touch 17. Never install telephone jacks in wet locations unless the jack
Resumen del contenido incluido en la página 12
Getting Started Caller ID System Operation Connecting Your Phone 4. Use the dial pad to enter the three digit area code there your phone numbers This section is a reference guide to the basic functions and operations of your cordless begins with. telephone. For more detailed descriptions of the operations and features of this telephone, refer to the Contents on page 1. SAVE /RE/PA 5. Press and hold down the button. 1. Carefully remove your cordless telephone from its
Resumen del contenido incluido en la página 13
TELEPHONE JACK TELEPHONE LINE CORD Caller ID System Operation Getting Started 6. Press the button to return to the STANDBY mode. / VOICE MAIL BASE UNIT POWER-IN BASE UNIT CONNECTION NOTE: The date and time will automatically set, if you have subscribed to the Caller ID ANTENNA JACK service from your local telephone company. TELEPHONE LINE C. RINGER VOLUME CONNECTION This function enables you to adjust the ringer volume from HI, LOW
Resumen del contenido incluido en la página 14
Getting Started Caller ID System Operation A. LANGUAGE This telephone offers English, Spanish and French languages for your convenience. TALK 1. Press the button and hold down. / VOICE MAIL 2. Press the TELEPHONE KEYPAD button. Press the button to confirm that EDIT 3. Press the button. /FLASH you have a dial tone. If you do not get a dial tone, review steps 3 t
Resumen del contenido incluido en la página 15
Cordless Telephone Operation Caller ID System Operation Function Operation Preparing for Use This unit contains the following special functions: Before you can use cordless telephone ,you must charge the HANDSET for 12 hours. Failure to do so will require recharging of the BATTERY PACK more often. A. LANGUAGE F. AREA CODE (See page 26 for more information on the BATTERY PACK) B. FIRST RING ON/OFF G. FLASH TIME 1. Place the HANDSET on the BASE UNIT for 12 hours .
Resumen del contenido incluido en la página 16
Cordless Telephone Operation Caller ID System Operation Deleting All Records in the PHONE BOOK Placing Calls D DIIR R 1. Press the button to enter the phone book list. (If the phone book is not full, the 1. Press the button, the Call Timer LCD screen will disply "NEWDATA", press scroll UP or DOWN to enter the phone starts to count. The HANDSET LCD Screen book list) will display "CALLS " and "TALK ", and the DEL 2. Press and hold down the
Resumen del contenido incluido en la página 17
Caller ID System Operation Cordless Telephone Operation Placing Calls from the PHONE BOOK Using the Headset Feature D DI IR R 1. Press the button. HEADSET Your telephone can utilize a headset (not included) to be connected to your HANDSET 2. Press the SCROLL UP or DOWN button to find the record you want to call. MICROPHONE for you to enjoy hands-free communication. 3. Press / VOICE MAIL Insert the small plug at the end of the headset the
Resumen del contenido incluido en la página 18
Caller ID System Operation Caller ID System Operation Caller ID System Editing the Name and Number in the PHONE BOOK This telephone automatically displays an incoming caller's name and telephone number D DI IR R 1. press the button. together with the date and time of the call. It records up to 80 calls and stores the data in Memory. 2. Press the SCROLL UP or DOWN button to find the record you want to edit. IMPORTANT: You must subscribe to the Caller ID service from y
Resumen del contenido incluido en la página 19
Caller ID System Operation Caller ID System Operation Call Waiting Saving in the PHONE BOOK When you subscribe to a Call Waiting service from your local telephone company, this D DI IR R 1. Press the button. The LCD screen will display "PHONE BOOK".(a record will be telephone will display the name and number of the second caller while you are having displayed if the phone book is full, the phone book can story up to 64 records) a phone conversation with your first caller. 1. Wh
Resumen del contenido incluido en la página 20
Caller ID System Operation Caller ID System Operation Viewing the Caller List Deleting All Records in the Caller List 1. Press the SCROLL DOWN button to view the latest Caller ID record, or press DEL 1. Press and hold down the /SCAN button while in the caller list, and display "ERASE ALL" the SCROLL UP button to view the first Caller ID record, press the SHIFT RIGHT button if the name has more than 11 digits. DEL 2. Press
