Resumen del contenido incluido en la página 1
OWNER'S MANUAL
L-D-C C-F CALLS BATT MSG DIR
AM RPT
PM
TOTAL
Option
IN USE/
CHARGE POWER
PAGE
2.4 GHz Cordless Telephone with Call Waiting Caller ID
PLEASE READ BEFORE OPERATING THIS EQUIPMENT
Model : TC924
#
NEW
Resumen del contenido incluido en la página 2
Contents Safety Instructions........................................................................................................... 3 HANDSET CONTROLS................................................................................................... 5 BASE UNIT Controls........................................................................................................ 7 Getting Started........................................................................................................
Resumen del contenido incluido en la página 3
Contents Function Settings.......................................................................................................21 A. Setting the Ringer Level................................................................................ 22 B. Changing the Language...............................................................................22 C. Turning the First Ring ON or OFF................................................................23 D. Setting the Time and Date.....................
Resumen del contenido incluido en la página 4
Safety Instructions IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electric shock and/or injury, always follow these basic safety precautions when using your cordless telephone equipment. 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the telephone. 3. Do not use this telephone near a bathtub, wash bowl, kitchen sink, or laundry tub, in a wet basement, near a swimming pool, or anywhere else where there is water. 4. Avoid using a telephone (o
Resumen del contenido incluido en la página 5
Safety Instructions D. If the telephone does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions. Improper adjustment may require extensive work by a qualified technician to restore the telephone to normal operation. E. If the telephone has been dropped or the case has been damaged. F. If the telephone exhibits a distinct change in performance. 16. Never install telephone wiring during a lightning storm. 17. Neve
Resumen del contenido incluido en la página 6
HANDSET Controls L-D-C C-F CALLS BATT MSG DIR AM RPT PM TOTAL 1. New Call/Msg Waiting (Message Waiting) LED Indicator: (New Call) Blinks to indicate that you have a new Caller ID call stored in memory. (Message Waiting) Blinks when receiving a Message Waiting signal, if you have subscribed to a Voice Mail message service from your local telephone company. (See page 14.) 2. Large LCD Screen: Shows call information, phone status, prompts and DIRECTORY (PHONE BOOK) items. 5 # NEW
Resumen del contenido incluido en la página 7
HANDSET Controls 3. Talk Button: Press to answer an incoming call or to place a call. Press to end a call. 4. HANDSET Volume Control (HI, MID, LOW) Switch: Select the receiver volume level (HI, MID, LOW). 5. TELEPHONE KEYPAD Buttons: Allows you to make a call depending on pressed button. (For TELEPHONE KEYPAD characters, see page 18.) 6. Temporary Tone (*) Button: Press to temporarily change the DIALING mode from PULSE to TONE for Rotary Service Users. (Press once before entering numbers to acce
Resumen del contenido incluido en la página 8
BASE UNIT Controls 1. TONE/PULSE SELECT SWITCH 2. POWER-IN CONNECTION JACK 3. TELEPHONE LINE CONNECTION JACK 4. BASE UNIT ANTENNA 5. IN USE/CHARGE LED INDICATOR 6. CHARGE TERMINALS 7. POWER LED INDICATOR PAGE 8. PAGE BUTTON 1. TONE/PULSE Select Switch 2. POWER-IN CONNECTION JACK 3. TELEPHONE LINE CONNECTION JACK 4. BASE UNIT ANTENNA 5. IN USE/CHARGE LED Indicator: (IN USE) Lights up to indicate that the HANDSET is in TALK mode. (CHARGE) Lights up when the HANDSET is placed on the BASE
Resumen del contenido incluido en la página 9
Getting Started Connecting Your Phone This section is a reference guide to the basic functions and operations of your cordless telephone. For more detailed descriptions of the operations and features of this telephone, refer to the Contents on page 1. 1. Carefully remove your cordless telephone from its shipping carton. If there is any visible damage, do not attempt to operate this equipment. Return it to the place of purchase. 2. Check to be sure you have all items that come with this cordless
Resumen del contenido incluido en la página 10
Getting Started 7. Install the HANDSET BATTERY PACK by plugging it into the BATTERY CONNECTOR inside the BATTERY COMPARTMENT. 8. Place the BATTERY PACK inside the BATTERY COMPARTMENT. BATTERY PACK 9. Slide the HANDSET BATTERY COMPARTMENT COVER firmly into place in its closed position. 10. IMPORTANT: Before initial use, charge the HANDSET for 12 hours. Place the HANDSET on the BASE UNIT with BATTERY TELEPHONE KEYPAD face up, and COMPARTMENT make sure that the CHARGE LED COVER indicator on the B
Resumen del contenido incluido en la página 11
Cordless Telephone Operation Preparing for Use Before you can use your cordless telephone, you must charge the HANDSET for 12 hours. Failure to do so will require recharging of the BATTERY PACK more often. 1. Place the HANDSET on the BASE UNIT for 12 hours. 2. After 12 hours, remove the HANDSET from the BASE UNIT . Before you can use your cordless telephone, you must charge the HANDSET for 12 hours. Failure to do so will require more frequent charging of the BATTERY PACK. NOTE: Depending on the
Resumen del contenido incluido en la página 12
Cordless Telephone Operation Placing Calls 1. Press the Talk button, the Call Timer starts to count. 2. Wait until you hear a dial tone and then dial the phone number. 3. When you have finished your call, press AM the Talk button again or place the HANDSET on the BASE UNIT. OR 1. Dial the phone number. 2. Press the Talk button. The number displayed will be dialed. 3. When you have finished with your call, press the Talk button again or place the HANDSET on the BASE UNIT. Redial F
Resumen del contenido incluido en la página 13
Cordless Telephone Operation Using the Headset Feature Your telephone can utilize a headset (not included) to be connected to your HANDSET for you to enjoy hands-free communication. Insert the small plug on the end of the headset into the HEADSET JACK at the right side of the HANDSET. Follow the procedures discussed in “Receiving Calls” and “Placing Calls” to receive and place a call. NOTE: When you plug the headset plug into the HEADSET JACK it automatically mutes the MICROPHONE and SPEAKER of
Resumen del contenido incluido en la página 14
Caller ID System Operation Caller ID System This telephone automatically displays an incoming caller’s name and telephone number together with the date and time of the call. It records up to 80 calls and stores the data in Memory. IMPORTANT: You must subscribe to the Caller ID service from your local telephone company to utilize this feature. Viewing Caller Information During Incoming Calls 1. When there is an incoming call, the name and the telephone number of the caller will automatically appe
Resumen del contenido incluido en la página 15
Caller ID System Operation Caller ID with Call Waiting When you subscribe to Call Waiting service from your local telephone company, this telephone will display the name and number of the second caller while you are having a phone conversation with the first caller. Second When a new call comes in while you are Caller MIN SEC talking, you will hear a notification beep from the HANDSET and the volume is momentarily First muted. The new caller’s name and phone Caller number, if available, appears
Resumen del contenido incluido en la página 16
Caller ID System Operation Caller List This phone automatically stores the last 80 calls received. It records call information such as caller’s name and telephone number together with the date and time of the call. The NEW CALL LED indicator will blink to indicate that you have a new Caller ID call stored in memory. Viewing the Caller List 1. With the HANDSET in STANDBY mode, press the SCROLL UP or DOWN button. 2. Any unviewed (new) calls will be displayed first. The most recent call will
Resumen del contenido incluido en la página 17
Caller ID System Operation Storing Caller ID Records into the DIRECTORY (PHONE BOOK) 1. Press the SCROLL UP or DOWN button to find the record you wish to store into the DIRECTORY (PHONE BOOK). 2. Press and hold the Re/Pa/Save button. 3. The display will show “SAVED.” 4. If you wish to edit the newly stored number, edit it in the DIRECTORY (PHONE BOOK) (page 19, “Editing a Stored Number”). 5. Press the Dir button to return to STANDBY mode. Note: When numbers are stored into the DI
Resumen del contenido incluido en la página 18
Caller ID System Operation Name and Telephone Number DIRECTORY (PHONE BOOK) This DIRECTORY (PHONE BOOK) lets you scroll through the list to find the person you need for one touch dialing. You can store up to 40 names and telephone numbers in the Memory. Viewing the DIRECTORY (PHONE BOOK) 1. Press the Dir button. 2. Press the TELEPHONE KEYPAD 2 /ABC to 9 /WXYZ button that c orresponds t o the first letter of a Caller’s name (a triple “beep” will sound if no entries are stored under those le
Resumen del contenido incluido en la página 19
Caller ID System Operation Telephone Keypad Characters The TELEPHONE KEYPAD buttons are used to enter characters when entering names and numbers. Press the appropriate TELEPHONE KEYPAD button to get the following characters. You can store a maximum of 18 characters on the letter icon and a maximum of 22 digits on the number icon. Keypad 1st 2nd 3rd 4th 5th 6th 7th 8th 9th Buttons Press Press Press Press Press Press Press Press Press 1 Space 1 & ‘ ( ) . Space 1 2 A B C a b c 2 A B 3 D E F d e f
Resumen del contenido incluido en la página 20
Caller ID System Operation Placing Calls from the DIRECTORY (PHONE BOOK) 1. Press the Dir button. 2. Press the SCROLL UP or DOWN button to find the record you want to call. OR Press a TELEPHONE KEYPAD (2/ABC to 9/WXYZ) that corresponds to the first letter of a Caller’s name. Press the SCROLL UP or DOWN button to find the record you wish to call. 3. Press the Talk button to dial the displayed number. 4. To end the call, either press the Talk button or place the HANDSET on
