Resumen del contenido incluido en la página 1
5.8 GHz Dual-Handset Expandable
2-Line Cordless Telephone with
Digital Answerer
43-3704
Memo Recording lets you leave messages for
yourself or others in your home or office, or record your
phone conversations. (See Voice memo on page 66.)
Call Screening lets you listen as a caller leaves a
message. (See Screening a call on page 62.)
Speakerphone lets you conduct a hands-free
conversation using the handset.
Handset Remote Operation lets you listen to your
incoming messages fro
Resumen del contenido incluido en la página 2
CONTENTS Caller ID and CIDCW (Caller ID on Call Introduction ................................... 3 Waiting) ........................................ 45 Important Information .................... 4 Viewing the Caller ID List ................ 46 FCC Statement .................................. 4 Deleting a Caller ID Message ......... 47 Surge Protection ................................ 5 Using the Caller ID Message List .... 47 Important Safety Instructions ........ 6 Call Waiting Deluxe Features
Resumen del contenido incluido en la página 3
IMPORTANT INTRODUCTION ! ! Your phone operates on Thank you for purchasing a RadioShack 5.8 standard radio GHz Dual Handset Expandable 2-Line frequencies as allocated Cordless Telephone. Unlike other by the FCC. conventional cordless telephones, your telephone supports up to two handsets on a It is possible for other single telephone line. You can add a radio units operating handset to any room in your home or office nearby on similar that has an AC outlet. No more running to fre
Resumen del contenido incluido en la página 4
Important Information IMPORTANT INFORMATION This telephone has been tested and found to comply with all applicable UL and FCC standards. As an ENERGYSTAR Partner, RadioShack Corporation has FCC STATEMENT determined that this product meets the ENERGYSTAR This equipment complies with Part 68 of the guidelines for energy FCC rules and the requirements adopted by the efficiency. ACTA. On the base of this equipment is a label that contains, among other information, a product identifier in
Resumen del contenido incluido en la página 5
In the unlikely event that your phone causes problems on the phone line, the phone company can temporarily discontinue your service. If this happens, the phone company attempts to notify you in advance. If advance notice is not practical, the phone company notifies you as soon as possible and advises you of your right to file a complaint with the FCC. Also, the phone company can make changes to its lines, equipment, operations, or procedures that could affect the operation of this phon
Resumen del contenido incluido en la página 6
Important Safety Instructions IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink, or laundry tub, in a wet basement or near a swimming pool. 2. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remot
Resumen del contenido incluido en la página 7
IMPORTANT CALLER ID INFORMATION To use Caller ID and Call Waiting, you must be in an area where those services are available and you must subscribe to those services through your local phone company. Where Caller ID is offered, one or more options are generally available: callers number only callers name only callers name and number If you subscribe to Call Waiting ID and Caller ID, the system can show you the incoming caller information, even when you are already talking on th
Resumen del contenido incluido en la página 8
Installation INSTALLATION Ô NOTE Ô Before using your phone, carefully peel the If your home has specially protective film off the display. The film wired alarm equipment protects the handset window during connected to the telephone shipment and is not necessary for use. line, be sure that installing the system does not disable your alarm equipment. SELECTING A LOCATION If you have questions about You can place the phones base on a desk what will disable alarm or table, or mount it o
Resumen del contenido incluido en la página 9
Your telephone connects directly to a Ô NOTE Ô modular telephone line jack. If your telephone wiring does not have a modular The USOC number of the jack, you can update the wiring yourself jack to be installed is using jacks and adapters (available at your RJ11C (or RJ11W for a wall local RadioShack store), or have the plate jack). telephone company update the wiring for you. Ô On a Desk Top 1. Plug one end of the supplied long modular cord into the TEL LINE 1/2 jack on the back of
Resumen del contenido incluido en la página 10
Installation 1. Make the AC adapter and the short telephone line cord through the hole on the bracket. 2. Plug one end of the modular cord into the TEL LINE 1/2 jack on the back of the base. 3. Insert the supplied AC adapters barrel plug into the DC IN 9V jack on the back of the base. 4. Slide the bracket into the notches on the base. 5. Plug the adapter into a standard AC outlet. Hook the cord on the notch of the bracket. 6. Plug the telephone line cord into the telephone outlet. 7.
Resumen del contenido incluido en la página 11
CONNECTING/CHARGING THE BATTERY PACK The phone comes with a rechargeable nickel-metal hydride (Ni-MH) battery pack in the handset, but not connected. Before using your phone, you must connect the battery pack, then charge it for about 1520 hours. 1. Press down and slide off the battery compartment cover. 2. Lift the battery pack out of the compartment. 3. Plug the battery packs connector into the socket in the compartment (the connector fits only one way), then place the battery pa
Resumen del contenido incluido en la página 12
Installation the display. Otherwise, the battery pack loses its ability to fully recharge. Using a damp cloth, clean the charging contacts on the handset about once a month. If you are not going to use your phone for an extended period, disconnect the battery pack. This increases the battery packs usable life. The supplied battery pack should last WARNING for about a year. If the battery pack o o Dispose of the old battery does not hold a charge for more than 2 pack promptl
Resumen del contenido incluido en la página 13
INSTALLING A BELTCLIP To attach the beltclip Insert the beltclip into the holes on each side of the handset. Press down until it clicks. To remove the beltclip Pull either side of the beltclip to release the tabs from the holes. USING A HEADSET You can make or answer calls with hands- free convenience using an optional headset 3 that has a /32-inch (2.5-mm) plug. RadioShack has a variety of headsets available. To connect the headset, gently flip open the rubber headset jack cover on the
Resumen del contenido incluido en la página 14
Display and Icons DISPLAY AND ICONS Example of the standby mode display Ringer off icon (when the ringer is off)/ day of the week and time / battery icon Handset ID and Banner Number of new Caller ID calls received (If there are no new Caller ID messages, the Handset ID appears here.) Appears ICON DESCRIPTION During Battery icons indicate the handset battery status. This Standby/ icon changes depending on the battery status (empty, Talk low, medium and full). Standby/ The Line icon indicate
Resumen del contenido incluido en la página 15
SOFT KEY FUNCTION Soft keys are keys that change function during the operation of the phone. There are three soft keys on each handset. Soft Keys allow you to: Access the main menu Store or edit phone numbers and Caller ID message The function of each soft key is determined by the icon that appears directly above it. For example, when the handset is in standby mode, pressing soft key 1 will activates Line1. When the handset is in talk mode, pressing soft key 1 displays the list of
Resumen del contenido incluido en la página 16
Main Menu Options MAIN MENU Ô NOTE Ô OPTIONS For Global Setup, Answ. Setup, and Deregister HS Your phone has six main menu options: menu options, make sure DirectLink Mode, Room Monitor, Handset the line is not in use and the Setup, Answ. Setup, Global Setup, and handsets are within range Deregister HS. Ô of the base. DEFAULT SETTINGS The default settings set from the factory match the features that most people use. You may not need to change them. However, there are a number of opt
Resumen del contenido incluido en la página 17
SETTING MENU OPTIONS USING THE INTERFACE Below are some tips for using the software interface on your phone. Press the MENU soft key to access the main menu. Use CID/VOL/ or REDIAL/P/ to scroll through options. Press the OK soft key to make a selection. Press the BACK soft key to return to the previous screen. Press END to exit the menu. If you do not press a key within 30 seconds, the phone will time out and exit the menu mode. When setting Day and Time, the time-out period
Resumen del contenido incluido en la página 18
Setting Menu Options confirmation tone, and DirectLink Mode Complete appears. 3. To return to normal mode, press the CANCEL soft key and then the OK soft key, or return the handset to the cradle. Room Monitor This feature allows you to monitor sounds in Ô NOTES Ô another room. Place the handset in the room you wish to monitor; it will function as You must have two a microphone. A second handset can be set handsets to use Room to function as a remote speaker, allowing Monitor feature
Resumen del contenido incluido en la página 19
2. Press CID/VOL/ or REDIAL/P/ to select Auto, Line1, or Line2. 3. Press the OK soft key. You will hear a confirmation tone. Selecting a Ringer Volume Ringer Volume lets you select one of three ringer volume (Off, Low, or High). 1. Press the MENU soft key. Select the Handset Setup menu, and then the Ringer Volume submenu. 2. Press CID/VOL/ or REDIAL/P/ to select Line1 or Line2, and then press the OK soft key. 3. Press CID/VOL/ or REDIAL/P/ to adjust the ringer settings (Ringer Volume O
Resumen del contenido incluido en la página 20
Setting Menu Options [Sweetheart], Star Spangled Banner [Star Spngl], Old MacDonald [Old MacDld]) You must set a separate ringer tone on each handset. 1. Press the MENU soft key. Select the Handset Setup menu, and then the Ringer Tone submenu. 2. Press CID/VOL/ or REDIAL/P/ to select Line1 or Line2, and then press the OK soft key. 3. Press CID/VOL/ or REDIAL/P/ to move the pointer. You will hear the ringer or melody as you scroll through the options. 4. When you reach the ringer tone
