Manual de instrucciones de Ikelite DSC-V1

Resumen del contenido incluido en la página 1

Digital Housing
instruction manual
for
Sony
DSC-V1
Housing
#6110.91

Resumen del contenido incluido en la página 2

Strobe Ikelite Digital Housing Mount Shutter Release instruction manual Night Shot Housing #6110.91 for Sony DSC-V1 Night Frame Quick Release Power Button Lens Port Mode Dial Rubber Lid Handles Snap Tray FRONT VIEW Shutter Release O'ring External Strobe Connector Zoom Exposure Index Focus Congratulations on your purchase of an Ikelite Digital Camera AE Lock Housing. Ikelite has over 30 years of experience in the underwater LCD Jog Dial Lid photographic and lighting market. Our products are d

Resumen del contenido incluido en la página 3

Closing the Housing Checking Controls Closing the Housing Checking Controls housing back 1. Place housing face down in your Once the housing has been closed, push the controls back into Shutter lap. place. Make sure they line up with the camera’s controls. Release 2. Check to see that there is an O'ring External o’ring on the housing back and T Tu ur rn n C Ca am me er ra a O On n that it is clean and in its proper Strobe Connector Turn the camera on and operate each of the housing contr

Resumen del contenido incluido en la página 4

This edge against Lubricants Diffuser and Deflector cont. Lubricants Diffuser and Deflector cont. Diffuser or housing 1. Ikelite provides silicone lubricant with the housing. We A diffuser and deflector are Deflector recommend that you use only Ikelite lubricant on Ikelite included with the housing. The material products as some other brands may cause the o’ring to swell diffuser is white transparent and not seal properly. plastic. The deflector is also white 2. Use only enough lubricant to lig

Resumen del contenido incluido en la página 5

3. Some of the controls have a short shaft and cannot be pulled Control Maintenance Control Maintenance out exposing the shaft for lubrication. In the unlikely event one Ikelite controls are designed to provide years of reliable service of these controls sticks or becomes difficult to operate you can with minimal maintenance. remove the control from the housing and lubricate it, or return 1. Push button controls require no maintenance other than rinsing the housing to Ikelite for maintenance. To

Resumen del contenido incluido en la página 6

General Tips General Tips 1. Due to the power required to operate the camera, flash, and LCD screen it is a good idea to start each dive with a fresh batteries. 2. Some cameras reset their flash to AUTO when the camera is turned on. If you prefer another setting be sure to select it. 3. As soon as you enter the water, take a moment and check the housing to see that it is properly sealed. 4. Next, check to see if there are any bubbles on the face of the lens port. If there are, take your finger a