Manual de instrucciones de American DJ Snap Shit DMX/D

Resumen del contenido incluido en la página 1

®
American DJ User Instructions
™
Snap Shot DMX/D
Caution! Always disconnect from main
power before replacing lamps or servicing unit.
Remember to always replace with same lamp
and fuse.
PIN 1 GND, PIN2 DATA-, PIN3 DATA +
1. Power Switch
2. DMX Addressing or Rate \ Intensity \ Duration
Switches
3 3.Mode Switches
1 2 45
4.DMX Input
5.DMX Output
Thank you for purchasing this American DJ® product. For your convenience this
product has been lamped and is ready to be used, there is no assembly

Resumen del contenido incluido en la página 2

Operating Instructions Duty Cycle Because the Snapshot DMX can be used for continuous output (ie while simulat- ing lightning). It can build up intense heat it and comes with a program to shut down the unit for a15 second cool down. The Fastest Rate, Brightest Intensity, Longest Duration setting will cause unit to shut down within 5 seconds. So plan your Show to make sure all units don’t turn off at same time. Stand Alone Mode 1. Disconnect power from strobe then turn off all dipswitches, exc

Resumen del contenido incluido en la página 3

DMX MODE Using the 1 thru 3 mode dipswitches you can control the intensity, duration, rate by DMX in 7 different ways with a DMX-512 Board. The following table show how the various settings these dip switches effect the way the DMX data should be sent. DMX Function DMX Data Assignments 1 2 3 4 5 6 7 8 9 10 1 2 3 4 on 1 2 3 4 5 6 7 8 9 10 1 2 3 4 Duration is Rate is set by DMX Intensity is first 1/2 cycle refresh*